Year1
- 温度：
- 350度
- 型号：
- LEOT
- 作用：
- 加热
Each pipeline of the equipment should be cleaned regularly, especially the filter screen cover at the system inlet. The technical staff of the Orant mold temperature machine manufacturer recommend that you clean it once a month.
Special attention should be paid to the fact that when cleaning, the switch of the mold temperature controller must be turned off and the power switch must be cut off. Never use water to clean the machine, otherwise it will easily cause an electric shock accident.
,
Mold temperature controller
The heat transfer medium of the mold temperature controller must be clean. For example, filtering measures should be taken before water enters the internal pipeline of the mold temperature controller. If conditions permit, pure water can also be used. If heat transfer oil is used, it needs to be replaced regularly. The time for oil change depends on the frequency of use and the temperature of use.
. Lower the temperature and keep it below
°C
minutes before shutting down the machine after get off work. Shut down the machine because the surface temperature of the heating tube can reach
°C. Sudden shutdown will cause the heat transfer medium to stop circulating, easily causing carbon to form on the surface of the heating tube, affecting the use of the unit.
Before use, be sure to check whether the cooling water is flowing and ensure that all valves are unobstructed to prevent damage to the mold temperature equipment due to insufficient cooling water.
Through the above introduction, we can clearly understand the requirements for the use of mold temperature controllers. I hope everyone must pay attention to the above precautions when using them. Of course, in addition, you should also pay attention to other aspects and do various things well. protective measures.
<=_
WhatsApp
