Nuoguang manufacturer MB02-Y0.18KW-C2 continuously variable transmission with one-stage gear

Shanghai Nuoguang produces products with one-stage gear continuously variable transmission. With one-stage gear continuously variable transmission. In recent years, the series of transmissions have been used in practice and have proven to have unique styles among its many transmissions. They are widely used in food, printing, papermaking, rubber, plastics, ceramics and various work production lines with many required process parameters. When the speed and speed change continuously. This series of transmissions is mainly composed of a compressed driving wheel device, a friction transmission mechanism, and a speed control mechanism. It is the most widely used transmission at present. Due to the reasonable design structure and stable performance of this series of transmission components, the transmission components of the transmission have been Special heat treatment, precision processing of the friction parts, easy operation, good lubrication, stable transmission, low noise, long service life and other characteristics.
Use
Please note that the speed of the continuously variable transmission must be adjusted when it is turned on. The handwheel should not be turned too fast when adjusting the speed. It is strictly forbidden to turn the speed-regulating handwheel when it is stopped. The speed control limit screw under the handwheel has been adjusted at the factory and should not be adjusted arbitrarily to avoid damaging the transmission parts. If the motor is replaced, be careful to retain the original motor flange with oil seal to prevent lubricating oil from flowing into the motor.
Lubrication
Select or special traction oil for continuously variable transmission, and the oil level cannot be lower than the center line of the oil mark. Replace it after the first phase of work, replace it after the second phase of work, and then replace it every other time. The replacement period should be shortened under severe working conditions.
, series continuously variable transmissions and cycloidal pinwheel reducers below model 1 can be lubricated with molybdenum disulfide grease or lithium-based grease.
Performance characteristics
High strength, it can rotate accurately without recoil when impact load is applied or the machine is reversed. It is suitable for continuous work and can also run forward and reverse
. The continuously variable transmission has a large speed range and a speed ratio of 100 rpm, that is, the output speed can be changed arbitrarily between
, coaxial structure input shaft, output shaft rotate in the same direction
, strong combination ability, can be combined with various types of reducers, low speed, large torque speed change effect
, stepless speed change Under the condition of allowable load, the set speed of the machine is constant
and the transmission machine is fully sealed, so it can be used in humid, dusty, and mildly corrosive working environments.
Transmission range
, Basic type/
, Transmission with one-stage gear reduction/
, Transmission with two-stage gear reduction/
, Transmission with three-stage gear reduction Gear reduction ()./
Continuously variable transmission model
Basic horizontal type vertical type
Primary gear
Secondary gear
Technical parameters
Input power.~
Output speed~/
Allowable torque