Year1
- 底部直径：
- 780
- 高度：
- 1200
Characteristic one:
>Acid-resistant For alkali, please refer to the polyethylene chemical resistance performance table
Note:
>If this melter is filled with liquids with a specific gravity of or below (weak acid, weak alkali and water), the general service life is to 20 years. If placed in a place sheltered from sunlight, wind and rain, the service life can be greatly extended to years.
>If acid-base liquid with a specific gravity between 1 and 2 is installed, the aging period is years and the service life is within 1 year.
If the acid-base liquid with a specific gravity between 1 and 2 is installed, the aging period is 1 year and the service life is within 1 year.
If the acid-base liquid with a specific gravity above is installed, the aging period is 1 year and the service life is within 1 year.
Characteristic 2:
>The temperature it can withstand shall not exceed degrees Celsius, and the maximum temperature shall not exceed degrees Celsius. Freezing resistance shall not be lower than zero degrees Celsius.
Characteristic three:
> Normal pressure products, that is, Puli containers, cannot be applied to positive or negative pressure exceeding normal pressure (atmospheric pressure) if stirring or acid-base pressure is required. When the concentration and specific gravity are above, it is best to install a reinforcing sleeve and thicken the wall thickness of the barrel. This feature needs to be paid special attention to especially in barrels with a volume exceeding the above. (If the concentration of sulfuric acid and nitric acid exceeds %, special-grade products must be used and it is best to install a reinforcing sleeve)
Feature 4:
This container is a rotomolded one-piece product with no welding and seamless features. Toxic, odorless, easy to clean and flexible to handle.
Note: Instructions for use of interface piping and reinforcing sleeves
(
) The interfaces or flanges installed on this container before leaving the factory may become loose or even Damage, be sure to check whether it is intact before receiving and installing.
The connections between containers or external pipes must be flexible or zigzag connections and supported by brackets. The pipes and interfaces must not be stressed to prevent the pressure of the container holding liquid and the weight of the pipe from damaging the interfaces and pipes. Container body.
After the joints and pipes are installed, the water must be tested to check whether there are leaks in the barrel and the connections between the joints and pipes.
The interfaces and pipelines should be inspected monthly, and any abnormalities should be repaired promptly.
The cold-rolled steel plates of our company's reinforcing sleeves should be installed when the container is not filled with liquid. The tightness should not fall off the barrel. It is suitable for reinforcement during long-distance transportation and handling. The paint surface of the sleeve will be damaged, so it must be repainted after installation to extend its service life. Butter must be applied to the fastening screws and nuts to prevent corrosion from affecting the strength.
WhatsApp
