Z-shaped steel machineZ-shaped steel machine priceZ-shaped steel machine

Duplicate steel section
1. Overall dimensions

. Song Dynasty
)

. Song type
)

, height
. Song type
)

below< br/>.宋体
)

Tons
.宋体
)
Steel quenching
Hardness
. Song Dynasty
)

Diameter ∮
. Song Dynasty
)

Press, in addition, the material is fed in and out, and a flat roller is added, and the rollers are assembled to straighten, adjust the deviation, and roll to form the shape.
.宋体
)

Inch chain drive,
.宋体
)

Type.
.宋体
)

.宋体
)

Points
.宋体
)

Composition type (
Arrangement of leveling rollers)
.宋体


2.
Production process of Songti tile press
Songti. During the production process of Songti tile press equipment, problems of one kind or another will inevitably occur. The most common one is the color steel plate. The problem of deviation will affect the production efficiency and product qualification rate of the machinery once deviation occurs. Therefore, we must know how to correct these errors. After a long period of research, we must know how to correct these errors. , After exploration, we came up with a method to adjust this problem. If the equipment board runs to the right, we need to use an iron block to pad the left corner of the Song Dynasty, or flatten the roller on the right, which axis it is. If the axis is off track, flatten it. The upper roller should be consistent with the lower roller. If the upper roller is flattened, the lower roller should also be flattened. Uniform and symmetrical rollers cannot be changed. . If it still doesn't work, first adjust the four equal corners of the front and rear rows of the color steel tile press from the main frame to the upper end of the bottom shaft to the same height, and then move from the first row to the last row. Arrange, find a piece of
Arial style. Line to straighten, check whether the lower axis is on a horizontal line, and adjust the left and right sides of the lower axis to be horizontal. Find the symmetry points for the first and last rows of color steel tile equipment, then tighten the lock nuts on both sides, draw a straight line front and back at the center of the middle runner, and secure the upper and lower shafts. After the gap adjustment is completed, the machine can be adjusted along the straight line. In fact, the remedy for board deviation requires long-term production and testing. There are different remedies for different deviation directions, but one thing to note is that whether it is a mechanical roller or other parts, Both sides need to be aligned, and only
Arial. Aligning both sides can maintain symmetry, and the shape of the product will be regular.