Square advertising pull the trigger square pull the trigger square pull the trigger pictures

Square Advertising Trigger
1. Square Advertising Trigger Parameters
Technical Parameters of Square* Advertising Trigger
Molding Machine Motor Power
Molding Machine Maximum Speed br/> Molding Color Steel plate thicknessbr/> Effective width of formed color steel platebr/> Expansion width of formed color steel plate
The unit includes forming host, feed rack, forming shear, hydraulic station, control box, laminating devicebr/> Square* advertising buckle The trigger is a fully automatic computer-controlled type, with automatic metering, automatic lamination, and automatic cutting
2.
Hydraulic system precautions
① The liquid level in the fuel tank should be kept above the center of the oil mark to prevent When the oil pump is empty and refueling, it must be filtered through the air filter to remove impurities.
②The working fluid of the oil tank is No. 1 anti-wear hydraulic oil. When the ambient temperature is lower than 10 degrees Celsius, you can use No. 1 anti-wear hydraulic oil. When the ambient temperature is higher than 10 degrees Celsius, you can use No. 1 anti-wear hydraulic oil. Other oils cannot be substituted. Normal operating oil temperature. When the oil temperature is too high, it is necessary to take cooling measures (add cooling water or blow with electric air) or stop the pump. It can only be used after the oil is fully cooled. When the oil temperature is too low, direct operation is not allowed and must be Taking heating measures, the temperature can be increased through external heating.
③Keep the hydraulic oil in the tank clean and do not allow impurities and moisture. During regular use, the oil filter is generally cleaned once a month, the tank is cleaned once every six months, and new oil is replaced at the same time.
④ Before starting the motor, the reversing valve must be in the middle position to prevent the motor from overloading.
⑤ When using the hose, avoid bending and sharp bends, and do not get too close to the hose to prevent injury from explosion. When the pressure resistance of the hose is lower than .times of the rated pressure, leakage and other aging phenomena will occur. The hose should be discontinued and replaced with a new one.
⑥Inspect once a year, clean each piece with light diesel or kerosene, and pay attention to protecting the mating surfaces