W-shaped steel forming machine 1W-shaped steel machine W-shaped forming equipment

Steel profile machinebr/> )
1. Technical parameters of steel profile machine
, Equipment dimensions
m*
m*
m
)
, equipment molding rows with two peaks
rows with three peaks
rows
)
, equipment weighs about
tons
)
, shaft Neck
(solid shaft)
)
, motor power
)
, oil pump power
)
, near plate thickness
)
, near plate width
)
, effective forming area
)
, chain
inch double chain
)
, Working speed
meters/
per minute
)
, equipment process forming
punching
cutting
)
production process and Configuration
Production process flow, loading
Pressure
Punching
Cutting
Discharging
2.
Production process of tile press
br/> . Tile press equipment will inevitably have problems of one kind or another during the production process. The most common problem is the deviation of the color steel plate. Once
. deviation occurs, it will affect the production efficiency and performance of the machinery. Product qualification rate, so we must know how to correct these errors. After a long period of research and exploration, we came up with a method to adjust this problem. If the equipment board runs to the right, it needs to use an iron block to cushion it. Go to the left
corner, or flatten the roller on the right. Flatten the axis at whichever axis it goes. The upper roller should be consistent with the lower roller.
.If the top is flattened, the bottom should also be flattened. A uniform and symmetrical roller cannot be changed. If it still doesn't work, first adjust the four equal corners of the front and back rows of the color steel tile press from the main frame to the upper end of the bottom shaft to the same height, and then move from the first row to the last row. , find a
.line to straighten, check whether the lower shaft is on a horizontal line, and adjust the left and right sides of the lower shaft to be horizontal. Find the symmetry points for the first and last rows of color steel tile equipment, then tighten the lock nuts on both sides, draw a straight line front and back at the center of the middle runner, and close the gap between the upper and lower shafts. After adjustment
. After the adjustment is completed, the machine can be adjusted along the straight line. In fact, the remedy for board deviation requires long-term production and testing. There are different remedies for different deviation directions, but one thing to note is that whether it is a mechanical roller or other parts, they need to be repaired. Align both sides. Only by aligning both sides can we maintain symmetry and the shape of the product will be regular.
)
.