Semi-automatic double-layer tile press pictures Semi-automatic double-layer tile press price Semi-automatic double-layer tile press

Semi-automatic double Semi-automatic doublebr/> 1. Technical parameters

Arrangement
Arrangement

, Equipment dimensions
)< br/>
, Equipment weight
tons
)

, Feeding plate thickness.
)

, Feeding Plate width
)

, tile press roll material
steel surface is plated with hard chromium, hardness
,
inner shaft diameter
.
)

, motor power
, hydraulic power
)

, rolling speed/
)

, bracket
industrial steel welding
)

, the entire electronic control system adopts industrial computer control

)
2 , Straightening principle
) During straightening, the profile will move from up, down, left and right, which requires a very loose gap between the straightening mechanism and the profile. The up, down, left and right sides of the straightening mechanism and
) the profile There can be a certain gap between the surfaces, and the size of the gap is between .mm. If deformation occurs during straightening and twisting
), the gap can be smaller.
) When straightening the profile, it is not possible to come into contact with both the appearance of the profile and the straightening mechanism. However, the contact with the straightening mechanism is very close to the part where the profile bends and deforms.
) The main thing is that in order to prevent the profile from deforming, the arc radius of the straightening mechanism's outline must match the arc of the section of the profile.
) For profiles with defects such as side bending and warping, apply enough pressure in the opposite direction through the straightening mechanism to cause it to deform for a long time
). If it is deformed in the opposite direction, If the deformation amount is appropriate, after rebounding, the profile can be completely straightened. If the formed profile is twisted and bent in one direction, the straightening machine must rotate in the opposite direction. The profile will undergo long-term plastic deformation. If
) the rotation angle is more appropriate, the profile will not be distorted after rebounding. This is the main principle of straightening of the color steel tile press
)