3feng 840 tile press equipment 3feng 840 tile press

Peak pressed tilebr/> 1. Technical parameters
Technical parameters of type tile press
, equipment installation dimensions
, feed plate thickness, feed plate width
, total weight of equipment Approximately
, forming pass arrangement, host power, hydraulic shearing power
, electronic control system, the entire machine adopts industrial computer control
, working speed/
, roll material of tile press The surface of the steel is plated with hard chromium and the hardness
2.
Preparation work and operating requirements before use of the tile press
Before using the tile press equipment, check whether the connections are firm and whether the installation bolts, Whether the nuts are tightened, enough lubricating oil should be added to the left and right chassis before power is turned on to start the machine for test run
First, run the machine empty and observe carefully to see if there is any vibration or noise, whether there is oil coming from the oil window, and whether the movements of the various parts are coordinated.
The mold can only be installed after everything is normal. When installing the mold, the power must be cut off, the motor belt or large gear must be moved manually, the steel profile machine can index the worktable, and raise the slide to the highest point. It is best to use an object to support it. between the workbench and the bottom surface of the sliding seat to prevent the sliding seat from falling naturally and causing an accident
The mold used in this machine requires one upper mold and six lower molds of the same size. Install the upper mold and one lower mold first, and then The mold is directly installed on the hexagonal runner worktable, and the upper mold is installed on the bottom of the sliding seat, and a backing plate of appropriate thickness is placed to ensure that after the upper and lower molds are closed, the surrounding gaps are even and the distance between the upper and lower molds is equal to the required tile blank The thickness
Based on the above mold, turn the workbench and install the remaining five pairs of lower molds. Only after the upper and lower molds are installed can the car be driven for tile pressing
Operation requirements of the tile pressing machine
Tile pressing The machine consists of unloading, forming, and post-forming cutting to produce color plates with smooth and beautiful appearance, uniform paint texture, high strength, and durability. They are widely used in industrial and civil buildings, such as factories, warehouses, gymnasiums, exhibition halls, theaters, etc. and walls. The components of the color steel tile press include the complete color steel tile press, computer control system, hydraulic pump station system, and fully automatic post-shearing system. Equipment features: The color steel plate equipment adopts high-level automatic control software, and the color steel tile press achieves production Information governance. The entire unit automation control system adopts a highly integrated network to make the automation system perform better. Automatic discharging, color steel tile press blank removal working procedures, mold installation and host test run are the same as above, then start the air compressor, vacuum pump, extruder, tile cutting machine, discharging machine tile press, color steel tile press and When parking the Vato conveyor, stop the extruder first, and then stop other equipment.