Color steel tile fully automatic press 860 tile press price fully automatic tile press equipment

type
1.
Technical parameters of type tile press

.宋体
)

.宋体
)

Feeding width
.宋体
)

Pai
.宋体
)

Hydraulic shearing power
.宋体
)

Control
.宋体
)

.宋体
)

Steel surface is plated with hard chromium, hardness
2.
. 宋体
) 宋体. Experience on using the tile press
宋体.press Problems of one kind or another will inevitably arise during the production process of tile machine equipment. The most common problem is the problem of errors in the color steel plates. Once deviations occur, it will affect the production efficiency of the machinery and the quality of the products. Efficiency, so we must know how to correct these mistakes. Through long-term research and exploration, we have come up with a method to correct this problem. If the equipment board runs to the right, it needs to use an iron block to cushion it to the left. On the corner,
Song Dynasty. Or you can flatten the roller on the right, and flatten the axis at which axis it deviates. The upper roller should be consistent with the lower roller. If the upper roller is flat
Song Dynasty. If it is flattened, the bottom should also be flattened. The uniform and symmetrical roller cannot be changed. If it still doesn't work, first adjust the four equal corners of the front and back rows of the color steel tile press from the main frame to the same height as the upper end of the final shaft, and then move from the first row to the last row. , find a thread to straighten, check
Arial. Check whether the lower axis is on a horizontal line, and adjust the left and right ends of the lower axis to be horizontal. Find the symmetry points for the first row and the last row of the color steel tile equipment
then tighten the lock nuts at both ends, draw a straight line in front and behind the base of the base runner, and adjust the gaps between the upper and lower shafts After it is done, you can adjust the machine along the straight line. In fact, the compensation method for board deviation requires our long-term production and testing. Different deviation directions have different compensation methods, but one thing that needs to be paid attention to is that whether it is the mechanical roller or the All other parts need to be aligned at both ends. Only by aligning both ends can we maintain symmetry and the shape of the product will be regular.