"Qingdao Epoxy Floor" approved epoxy mortar mid-coating material

Batch-scraping epoxy mortar mid-coating material
Two batches of putty are used on the surface of the primer after it has dried (approximately 1 hour at ℃) to ensure the epoxy floor's resistance to wear, pressure, collision, and water. , mineral oil, acid-base solution and other properties and adjust the flatness of the ground. . Use purpose quartz sand or emery and solvent-free epoxy batch scraping material as the first epoxy mortar, which must be fully stirred and evenly scraped. This channel is mainly used to enhance the wear resistance and pressure resistance of the ground.
Use a sandbag dust-free rolling sander to polish the first putty and vacuum clean.
Use purpose quartz sand or emery and solvent-free epoxy batch scraping material as the first epoxy mortar, which must be fully stirred and evenly used to enhance the wear resistance and flatness of the ground.
Use a sandbag dust-free rolling mill to polish the first epoxy mortar and vacuum clean it.
After the two coats of epoxy mortar are dry, if there are pits or cracks, they should be repaired first, then polished with a flat sander to make them smooth and vacuumed.
The mesh number of quartz sand used is determined by the on-site engineer according to the specific conditions of the ground.
Construction Precautions
Construction can only be carried out when the ambient temperature at the construction site should be higher than ℃ and the relative humidity should be less than %.
The constructor should keep records of the construction location, time, temperature, relative humidity, floor surface treatment, actual materials, etc. for reference.
Relevant equipment and tools should be cleaned immediately after coating application.
Safety technical requirements
Warning tapes and warning signs should be hung around the construction site.
. It is strictly forbidden to work with open flames and smoking within 1 meter of the construction site.
When using a high-pressure airless spray pump, the ground wire should be properly connected.
, paint and thinner should be placed in a well-ventilated warehouse.
Pay attention to personal protection when working.
. The use of power tools must be done by a dedicated person and the power must be cut off before leaving the site.