Hercules cleaning machine K2195TS special cleaning machine for chemical plants

[Hercules High Pressure Cleaner Product Introduction]:
Integrated trolley design, steel woven high-pressure hose cable with cable drum, powerful rotating spray boom body with storage rack for storing safety cut-off spray gun cleaning interruption The built-in bracket in the fuselage can be used to place the spray gun and spray boom.
[Technical parameters of Hercules high-pressure cleaning machine]:
Product model:
Weight:.
Supply current
Maximum inlet water temperature ℃
Maximum self-priming Height.
Steel Woven High Pressure Hose
Output Power.
Supply Voltage:
Adjustable Operating Pressure: -br
Water Flow/()
Dimensions (length, width and height): &#;
[Methods for troubleshooting high-pressure cleaning machines]:
①. The pressure of the high-pressure cleaning machine is unstable or intermittent after starting. Most of the reasons are due to the high-pressure water pump or It is caused by air being sucked into the water inlet pipe. At this time, you need to check whether the pressure of the water source is enough. If the water inlet filter is clogged, if you find that the water inlet filter is clogged, remove the filter and clean it with water
②. High-pressure cleaning If there is an abnormal squealing sound during the operation of the machine, we only need to inject ordinary butter into the oil injection hole of the motor to solve the problem. There is a certain working pressure during operation but the rated pressure of the equipment cannot be adjusted. First, the high pressure must be judged. Does the nozzle hole diameter match? If the pressure still does not rise after replacing the high-pressure nozzle, you need to check whether the pressure regulating valve is adjusted in place. If the fault persists after eliminating these two situations, it means the sealing component (water seal) inside the pump
③The high-pressure cleaning machine is in If the pressure drops after a certain period of normal operation, first check whether the high-pressure nozzle is seriously worn. Secondly, you need to check the pressure regulating valve and the sealing components inside the water pump respectively.
④. When the high-pressure cleaner is running, the high-pressure pipe vibrates violently, which indicates that the valve is working disorderly and needs to be repressurized. When the high-pressure cleaning machine is operating normally, the pressure of the pressure regulating valve is normal but the high-pressure water gun does not discharge water or the water jet sprayed by the high-pressure nozzle is irregular and scattered. This indicates that the high-pressure nozzle is blocked by foreign matter and needs to be removed and cleaned.
⑤ Observe through the window during regular maintenance of the high-pressure cleaning machine. If the crankcase lubricating oil is found to be turbid or milky white, it means that the oil seal in the high-pressure water pump is not tightly sealed or has been damaged. If the impurities in the water are not replaced in time, the crankshaft and The service life of the connecting rod results in complete damage to the high-pressure water pump.