Xiuwu European solid wood door pictures, original wood door manufacturer, how to identify the quality of solid wood doors

欧式实木门：

修武欧式实木门图片，原木门生产厂家，怎样辨别实木门好坏

原木门：

修武欧式实木门图片，原木门生产厂家，怎样辨别实木门好坏

实木复合门价格：

修武欧式实木门图片，原木门生产厂家，怎样辨别实木门好坏

Pictures of Xiuwu European-style solid wood doors. How do original wood door manufacturers identify the quality of solid wood doors? The appearance must be beautiful: the surface paint film of the wooden door must be smooth, bright, and free of quality defects such as dripping, bubbles, wrinkles, etc., and no corrosion spots, dead joints, or damage; The wood used for the door cover should be the same as the wood of the door leaf, the color of the decorative panel and the wooden lines should not be too different, and the tree species should be the same.
The door leaf must be square and not warped: the door leaf can just be inserted into the door frame and match the door frame: if the gap between the door leaf and the frame is large, it is mainly because the planing is not accurate during installation or the door frame is not perpendicular to the ground. The door leaf can be Remove and plan again; if the door frame is not vertical, use gaskets inside the frame plate to straighten it.
The hinges must be accurately positioned and installed firmly: if the hinges are not aligned correctly, it will cause the door leaf and frame cover to not match the door opening and closing smoothly. You can first unscrew one screw for each hinge and then adjust the fit between the door leaf and the frame. After the repair is correct, tighten all the screws. If the hinge screws are short or if the screws are screwed in without tightening the screws or if the screws are screwed at an angle, the door leaf will swing. Suitable screws should be replaced. The screws must be straight. The screws should be nailed in first/the rest should be screwed in. Pictures of Xiuwu European solid wood doors. How do original wood door manufacturers identify the quality of solid wood doors.
. The door lock must be opened and locked smoothly. The two parts on the door leaf and door frame must match: Improper installation of the lock will cause the door leaf to open and close uneasily. The deadbolt plate should be removed and the tongue groove should be repaired with a chisel. The position of the deadbolt mouth of the door frame should be adjusted before installation. In addition, the opening direction of the door must also meet the requirements.
. There must be base material inside the door cover: when the door cover is made of blockboard or density board, the base board should be fixed on the base keel of the door frame before nailing the lines; the door cover should be made of wood into a frame and then planed, Plane it straight and then assemble it into shape and install it on the wall, then cover the base board and decorative board. If you tap the side panel of the door cover with your hand and make a hollow sound, it means that the bottom layer is not padded with blockboard and other base boards and should be removed and redone. Picture of Xiuwu European solid wood door. How to distinguish the quality of solid wood door from the original wood door manufacturer.