Year1
- 额定电压：
- 220VAC
- 外壳防护：
- IP65
- 外形尺寸：
- 260x351mm
Applicable places:
This product B explosion-proof lamp is suitable for complete work in flammable and explosive places, used in various indoor and outdoor workplaces, China's coal industry, PetroChina, Sinopec, Suitable for fixed lighting needs of CNOOC, electric power, metallurgy, railways, steel, ships, military, aerospace, public security firefighting, chemical industry, government departments, venues, transportation, and large enterprises.
Two structural characteristics:
This product B explosion-proof lamp strictly complies with the requirements of B "Electrical Equipment for Use in Explosive Gas Environments" and other relevant standards, and can be used safely in flammable and explosive dangerous places. Works reliably.
Use high-efficiency gas discharge lamps as the light source. They have high light efficiency and long life. The average service life is less than an hour. They have high luminous efficiency, good light and fog transmission, and uniform illumination.
The shell is made of cast aluminum alloy, which has high strength, strong corrosion resistance and good impact resistance. The surface adopts the most advanced spraying technology, which can withstand long-term exposure to the sun, rain and various corrosive properties. It can be used reliably in the environment, does not rust, does not discolor, has good electromagnetic compatibility, and will not cause interference to the surrounding environment. Low failure rate, simple and convenient to use. It is light in weight and can be installed in many installation methods, such as boom-mounted, wall-mounted or ceiling-mounted.
Three technical parameters:
Explosion-proof mark: B/
Rated voltage:
Shell protection:
Insulation level:
Anti-corrosion level:< br/> Cable inlet thread
Pitch-to-height ratio:
Overall dimensions
Total weight:
Four quality assurances:
This product strictly complies with: International Quality management system standards are used for quality control to ensure that product quality is higher than national standards and safety meets design requirements. Products are subject to an annual warranty (light source warranty year) from the date of purchase. If the product fails under normal use, the company will be responsible for free. maintain.
Five warm tips:
●During transportation, pack the lamps in the provided cartons and add foam for shock absorption.
●When replacing the light bulb and wiping the glass, you must turn off the power switch and wait for the lamp to cool down.
●When in use, there will be a certain temperature rise on the surface of the lamp. This is a normal phenomenon and the center temperature of the transparent parts is relatively high and should not be touched.
●The lamp suddenly goes out during operation and cannot emit light immediately when it is turned on again. This is a normal phenomenon. Wait for it to cool down for ~ minutes and then turn on the switch again for normal lighting. Try to avoid hot start to avoid damaging the bulb or burn.
●When installing lamps, the lamps should be safely grounded nearby.
●When replacing a light bulb, try to choose the same type of light bulb and do not change the power of the light bulb at will
WhatsApp
