Maintenance of motor vehicle inspection lines

As a commonly used testing equipment in the motor vehicle industry, motor vehicle testing lines have very high requirements for accuracy. To ensure the accuracy of testing, the motor vehicle testing lines need to be maintained regularly. The details are briefly introduced below.
Every month of use, you should focus on checking the sideslip sensor. The output signal of the sideslip sensor should not exceed the specified value.
When the motor vehicle detection line is not in use, the sliding plate must be locked to prevent damage to the sensor from frequent shaking caused by external factors.
Do not park vehicles or pile up debris on the surface. Remove muddy water and garbage promptly to prevent them from immersing into the side sliding table and causing damage to the table body and sensors.
After using it for several months, in addition to the above maintenance work, you also need to remove the sliding plate, check the rollers and guide rails under the sliding plate, check whether there is dirt, deformation, looseness, rust, wear, etc. in each part, and clean and tighten it. Fixing and lubrication work should be carried out, and seriously worn parts should be replaced as appropriate.
After using it for several months, in addition to the above maintenance operations, it is also necessary to check whether the lever mechanism, return device and linkage device of the measuring device are flexible. If the motor vehicle inspection line is inflexible or lagging, it should be cleaned and lubricated in time. If necessary, repair or replace relevant parts.
The above is about the maintenance of the motor vehicle inspection line. I hope that in your daily life, you can take more care of the motor vehicle inspection line when using it, so as to extend its service life. More content can be found on the company's website::, welcome new and old customers to log in for consultation.