Professional stone renovation and caulking construction in Yongchuan, Chongqing

& Chongqing Yongchuan professional stone renovation and caulking construction
Telephone
Tools and processing steps required for stone grinding and polishing
Although the stone is hard in texture, it has been used for many years and its own natural Weathering, coupled with improper care, often causes the stone to lose its original luster, and scratches, dents, etc. appear on the surface, seriously affecting the decorative effect of the stone. But if you want to re-pave it, it will not only consume a lot of time, but also cost a lot of money. In fact, now that there is a stone renovation process, it is easy to renovate the stone and restore it to its original brightness, which is economical and time-saving.
Shallow renovation of the granite floor should be carried out in the order of front, back, left and right, and safety protection should be provided around the area (guardrails and yellow warning signs are placed). Use diamond pads and weighted scrubbers to water-sand the Wulian flowers. Use a refurbished weighting machine to connect the diamond pad connecting piece, diamond pad, and add water to polish the Wulian ground. Add water during sanding to prevent the ground from drying out. You can use a wiper to scrape away the sewage to check the effect, which usually takes about ten minutes. Use a water suction machine to suck up the sewage and replace the diamond pad. Use the same method to polish, which usually takes about fifteen minutes.
Use the above method to replace the diamond pads in sequence:,,,,. Special note: The three groups of , , and 2 need 20 minutes to ensure that the grinding marks of the previous process are removed. Absorb the sewage and clean it up. Use a hair dryer to dry the ground, especially the joints. After the ground is completely dry, put the polishing crystal agent on the ground at the standard of one spoon for two square meters, and add a little bit of the crystal surface agent. liquid.
Use a floor scrubber (a heavy-duty floor scrubber must be used), needle disc, red sheet and steel wool to polish. Add a small amount of liquid from time to time to prevent the crystal surface agent from drying out. Repeat the steps of grinding and adding additives. Depending on the actual conditions of the fire-burning board, it will take about twenty minutes to grind a four-square-meter floor. You can use a glass scraper to check the brightness of the floor.
There are also some precautions when renovating stone. Depending on the degree of damage to the stone, use a refurbishing machine with different diamond discs for polishing. When polishing, you should follow the texture of the stone until the surface of the stone is smooth and flat, and the color is uniform. After the stone is renovated, it can be restored to its original appearance and regain its charm.