Year1
- 规格：
- 2CY-12/2.5
Gear pumps are suitable for transporting lubricating oil or other liquids with properties similar to lubricating oil that do not contain solid particles and fibers, are non-corrosive, have a temperature not higher than ℃, and a viscosity of ~, and are used in hydraulic rotation systems.
Gear pump
It mainly consists of gear, shaft, pump body, pump cover, bearing sleeve, shaft end seal, etc. The gears have higher hardness and wear resistance after nitriding treatment. Installed together with the shaft and run in a replaceable bushing. The lubrication of all parts in the pump is automatically achieved by using the conveying medium when the pump is working.
The four bearing sleeves in the pump are installed floatingly in the pump, and the end clearance is automatically adjusted according to the working pressure. Therefore, the pressure of the pump is stable, the output flow pulsation is small, and the solution efficiency is high.
Looking toward the pump from the extended end of the main shaft, it rotates clockwise. Stainless steel gear pumps can be produced according to specific operating conditions and user requirements.
Application range of series gear pumps
Can be used as transmission and booster pumps in fuel delivery systems
Can be used as fuel pumps for delivery, pressurization and injection in fuel systems
It can be used as a hydraulic pump to provide hydraulic power in the hydraulic transmission system
In all industrial fields, it can be used as a lubricating oil pump
Precautions should be paid to the gear pump during transportation
Gear oil pump< br/>The device is fixed on the pad inside the packaging box to prevent damage to the pump during normal loading, unloading, and transportation. The inlet and outlet of the pump are blocked with pipe covers or seals to prevent debris from entering the pump cavity.
If the pump is not installed and operated immediately, or the pump cannot be operated within a period of time after installation on site, the pump device must be protected as follows
Stored in a dry and clean place
The pump chamber should be Fill with oil
Be sure to seal the cover or sealing port on the pump inlet and outlet correctly
Rotate the pump shaft at least a few revolutions per week
Exposed parts of the pump that are not painted Coat the surface with a rust inhibitor compound
Cover the pump and motor drive with plastic or waterproof canvas.
. The new pump shall not be disassembled without the authorization of the factory.
Series gear oil pump performance parameter table
Model
Flow rate
Speed
Discharge Pressure
Necessary steam
Erosion allowance
)
Efficiency
Electric motor< br/>
Power
Model
< br/>
WhatsApp
