Quick-drying stamping oil Quick-drying stamping oil factory Shanghai quick-drying stamping oil manufacturer direct sales Nito supply

Quick-drying stamping oil Quick-drying stamping oil factory Shanghai quick-drying stamping oil factory direct sales Nito supply
Quick-drying stamping oil
rb r, ). Volatile stamping oil product introduction Volatile stamping oil is a comprehensive Synthetic water-soluble stamping oil (also known as punching oil), the product can also be used as a lubricant for plastic forming operations such as extrusion, pressing, and tube drawing. This product uses a new technology of lubrication synergist, completely free of chlorine and sulfur components, which greatly improves the performance of the product. Especially suitable for high-intensity operations such as punching, stamping, tapping, and grooving. At the same time, it is also very suitable for plastic forming processing. This product contains various additives such as exquisite oily agents and rust inhibitors. It has good hydrophilicity and processability, and has good protective properties for the mold. Volatile stamping oil product applications Volatile stamping oil can be used for various plastic forming operations such as extrusion, pressing, stamping and drawing of various types of metal sheets. Such as silicon steel sheets, carbon steel, stainless steel, aluminum alloys, non-ferrous metals and their alloys, etc. The concentration should be slightly higher when stamping silicon steel sheets and stainless steel. Basic properties of volatile stamping oil Original properties Unit Appearance Amber yellow liquid Density @??/. Viscosity ° Product number Flash point (D closed) ° Freezing point ° Autoignition temperature (D) ° Use dilution ratio: Aqueous solution properties Unit vapor pressure (°) The value of the volatile concentration. The wear resistance test of the concentration is very good. The wear rate and noise removal effect are shown in the picture on the right. Note: The original solution is irritating to a certain extent: if it comes into contact with the skin, rinse it with plenty of water. Eyes: Strong irritation before dispensing Skin: Mild irritation Respiratory tract: Mild irritation Ingestion: May cause mouth and tongue irritation: Handle the solution after dispensing carefully to avoid contamination. Metal particles and metal salts, lubricants and microorganisms can cause harm to the solution. In some cases (such as heavy metal contaminants such as chromium, cobalt and nickel) may cause special harm. : Environmental protection: This product has poor biodegradability under anaerobic conditions. For example, if it is discarded into the soil, changes in its components may affect the degradation rate, but all of them can be biodegraded. Product will disperse as an emulsion or water. It can be degraded in an aerobic environment, and the degraded products will not harm the environment. : Fire extinguishing method: Because it contains a lot of water, it does not support combustion. After the water evaporates, impurities remain and can burn at high temperatures. Relatively speaking, emulsions that contain a lot of water and are very thin cannot burn. Fire extinguishing methods: Use foam, dry powder or water to extinguish fire. : Handling and Storage: Keep container tightly closed when not in use. Do not weld heat or invert the container. This product will release hydrogen chloride when heated excessively. Therefore, the storage temperature should not exceed °C. Shanghai Nito Industrial Co., Ltd. Contact person: Manager Niu Tel: Website: