Alcohol-based fuel electronic ignition energy-saving stir-fry stove, 13928895128

Electronic ignition energy-saving alcohol-based frying stove
Instruction manual
Electronic ignition energy-saving alcohol-based frying stove uses alcohol (methanol) as the main fuel. Environmentally friendly, energy-saving, powerful, smoke-free and non-toxic, it complies with national environmental protection requirements and is widely used in catering industries such as Shadian hotels, government agencies, military schools, etc. The automatic ignition power of this stove can be adjusted freely to save fuel and solve the safety hazard of accidental fire due to leakage in the stove core. It is extremely convenient to use.
1. Installation method

Connect the fan power cord.

Connect one end of the oil pipe to the oil input end of the single frying furnace and the other end before putting it into the oil tank.
2. Instructions for use

Open the fuel tank ball valve switch to allow fuel to flow freely into the fuel pipe.

The oil control switch needs to be turned to / (also half position) and the air valve switch in front of the panel should be turned to the middle.

After the power is turned on and the ignition is successful, turn the fan to the maximum and adjust the fire power to the required fire power for normal use.

When you are done using it, turn off the power and then close the oil valve to the middle and finally close the damper to the middle.

Turn off the oil pipe ball valve switch to avoid accidental fuel leakage.
3. Solemn reminder

The installation location of the fuel tank should be away from the fire source, air circulation, and sunlight should not be directly exposed to a place higher than the stove surface.

Remember to stay away from fireworks when adding fuel.

After use, the oil pipe ball valve switch should be turned off and the oil tank pipe switch should be checked frequently for oil leakage.

There is too much oil left in the stove core. The liquid level has immersed in the ignition needle. The oil valve is in a closed state. First igniting and then opening the oil valve will cause ignition difficulties or failure. Manual ignition should be used to burn off the remaining oil in the stove core. The oil ignites according to the normal procedure.

When the stove core is ignited, high voltage will be generated. Do not disassemble it or change the use without following the prescribed operations. Accidents may occur!
r