FQW series mining pneumatic submersible pump

>Pneumatic submersible pumpQ series pneumatic submersible pump direct sales of high quality mining submersible pump
>Q series mining pneumatic submersible pump
>Q series mining pneumatic submersible pump is a self-developed A new product, the Q series mining pneumatic submersible pump adopts a mechanical product in which the rotor and the pump body are coaxially connected. It adopts a vertical structure and a lower pump type. Factory direct sales
>Q series mining pneumatic submersible pumps are suitable for drainage operations in places containing gas and coal dust explosion hazards. They can be widely used on any working surface underground in coal mines to transport groundwater containing coal powder and sediment particles. Safe, reliable, and effectively improve on-site air quality.
>Technical features of Q series mining pneumatic submersible pump
>Q series mining pneumatic submersible pump for coal mines has a compact structure and is easy to move, assemble, disassemble and maintain. The vortex of the pump body adopts a high-efficiency and energy-saving hydraulic model, and the impeller is specially designed. This water pump has the advantages of strong sewage discharge capacity, large flow rate and high lift.
>Q series mining pneumatic submersible pump
Structure and working principle
>Q series mining pneumatic submersible pump mainly consists of three parts: pump body, air motor and overflow.
>Pump body part: It is divided into upper and lower chambers, with a sealing ring in the middle to separate air and water. The sealing ring adopts spring sealing, and uses the pressure of air and water to cause high-pressure air and water to enter the inner walls of the upper and lower sealing rings respectively, causing them to expand inward and enhance the sealing effect.
>Pneumatic motor part: composed of rotor, turbine, bearings, etc. Using compressed air as power, the impact turbine drives the rotor to rotate at high speed to perform work.
>. Overflow part: composed of water wheel, pump cover, suction port, pump base, etc. The water wheel is installed on the rotor shaft in the lower cavity of the shell. Compressed air is sent in from the air inlet. The rotor rotates to drive the water wheel. Under the action of centrifugal force, the water in the water wheel is pressed into the water outlet vortex of the shell and discharged along the water outlet pipe. .
>Q series mining pneumatic submersible pump
Technical parameters
% />