Supply high pressure Roots vacuum pump, negative pressure Roots blower, negative pressure Roots blower

别名：

负压罗茨真空泵

物流：

托运

包装：

木箱

Use and Maintenance
Good daily maintenance and correct use are the keys to the good operation of the three-blade Roots blower and to extending the service life of the Roots blower. Users are kindly requested to perform daily maintenance according to this to reduce unnecessary losses< br/> . There must be good ventilation in the machine room, and air exchange and heat dissipation equipment must be installed
. The temperature of the inlet air should not exceed Celsius
. The bearing temperature should not exceed Celsius
. The direction of motor rotation must be Run in the direction of the arrow on the fan belt cover and the cover on the side without pulley. Reverse rotation is strictly prohibited
. During normal operation of the three-blade Roots blower, it is strictly prohibited to completely close the exhaust valve and overload operation is strictly prohibited
/>. The sewage and oil storage volume in the aeration tank are lower than the vernier scale, the air pressure gauge has no pressure display, and the oil dripping nozzle has no oil droplets. It is strictly prohibited to operate.
. Check the oil storage capacity and oil dripping amount of the fuel tank every day. Each oil dripping nozzle should be controlled to drip every minute. If the oil drips too much, the oil will easily spray into the sewage pool and cause waste. If there is too little oil, it will easily cause noise and cause the machine to heat up. Cylinder
Before using a new machine or shutting it down for more than one day, the air filter must be removed, a small amount of lubricating oil should be injected into the main machine, and the main machine pulley must be manually turned until it runs freely before it can be put into use.
. The lubricating oil must be replaced within the first few hours of use of a new machine. If the quality turns black or thickens later, the lubricating oil must be replaced in time. Replacement method: Open the oil tank cap, remove the oil supply filter element, and clean the filter element to allow all residual oil to flow out quickly. Please use the hand blower or air compressor to blow out the residual oil from the oil filling port, and clean the oil dripping nozzle at the same time.
. Frequently check whether there is air leakage or oil leakage.
When disassembling the three-blade Roots blower, measure the matching dimensions, keep records, and mark the parts to ensure The original coordination requirements can be maintained after assembly. Maintenance and inspection should be formulated according to the specific use. It is recommended to overhaul once a year and replace lubricating oil and related wearing parts.