Sewage water treatment equipment

Start-up sequence
Turn on the water pump motor first
After the water pump motor runs normally, then turn on the water pumps in sequence
, the backup pump does not need to be turned on
Check after starting up
Record the filter Pressure gauge index, check whether backwashing is required, check the operation of the water pump, whether it is running smoothly and without noise, check whether each dosing system is operating normally, go to the swimming pool and visually check whether the water is flowing out of each water injection port normally.
Folding
Backwash function
Inspection before starting
If the pressure gauge reading on the sand filter tank is higher than /㎡ or above, the sand filter tank needs to be backwashed immediately
Confirm that the relevant water pump that needs to backwash the sand tank has stopped running
Adjust the multi-way valve
on the sand filter tank to the backwash state
※Confirm that the relevant valves on the pipeline are in the correct position Location.
Backwash sequence
First run the water pump to check and observe the clean water mirror on the sand tank until the water is clean and then turn off the water pump.
Note: If the backwash water cannot be checked, the duration of each backwash should be minutes.