How to reduce the need to replace steel balls in the dryer multiple times

During the operation of the dryer, it is not uncommon for steel balls to be damaged. So how can we avoid the phenomenon of repeated replacement of steel balls? Henan Songshan Heavy Industry will give you some suggestions. . The steel balls of the dryer should not be stacked in the open air, not exposed to the sun or rain, and the ambient temperature should not change drastically.
Before grinding, grinding equipment should feed appropriate materials into the mill, and do not grind excessively before stopping the grinding. When clearing and dumping balls, don't grind for too long. Before clearing and dumping balls, it should be properly ventilated and cooled.
During operation, attention should be paid to reasonable ball distribution, maintaining a certain high material-to-ball ratio, and reasonably controlling the filling rate of materials and steel balls in the mill.
Steel balls of different qualities and brands should not be mixed in the warehouse.
There are two main forms of edge transmission of the dryer. One is to use a high-speed motor for single transmission at the edge. When the high-speed motor drives the main reducer device, the large gear installed on one end of the dryer is driven by the small gear. drive. For larger equipment, an auxiliary motor and reduction device will be installed on the other end of the motor. The second is to use a low-speed motor edge transmission method, eliminating the need for a main reducer, but the price of the required motor is very high.
Article sourcebr/> Three-cylinder dryer
Slime dryer/
Dryer application scopebr/>