flat head tower crane, flat head tower crane, tower crane, tower crane

Titlis flat-head tower crane has a rated lifting moment. The maximum lifting weight that can be lifted at the maximum arm length is tons. The combination of arm lengths is in descending order. It can be combined into a total of different lengths. The minimum arm length is. It is very convenient to use and meets the requirements of / tower type. Crane and tower crane safety regulations and other standards. Compared with traditional leaded tower cranes, this tower crane has the following advantages
) It greatly reduces the lifting capacity requirements of the required lifting equipment for disassembly and assembly of the tower crane. Due to the elimination of the tower head, the flat-head tower crane has seven units with small mass and low installation height. The maximum installation height can be lower than other tower cranes of the same level. When installing the boom of an ordinary tower crane, the boom, tie rods, etc. must be connected on the ground before hoisting the whole machine. At this time, the requirements for the lifting equipment are the highest, and a large lifting capacity and lifting height are required. Because after the arm root pin is connected, the boom must be much too high before the boom lever can be trained properly. Safety accidents are prone to occur when installing the boom. However, the installation of flat-head tower cranes has been completely improved.
) Suitable for cross-tower operations. Since the tower head of the flat-head tower crane is eliminated, the overall height can be greatly reduced when the towers are working across each other. It has the advantages of reducing the overall installation time, low requirements for installation equipment, reducing the pressure of each tower crane, and using smaller tower body sections and chassis.
) Suitable for construction in situations with special height requirements. Since there is no tower head, the effective height of the hook is greatly increased and the space utilization rate is high. Therefore, it is very suitable for occasions with special height requirements, such as construction under high-voltage lines.
) Suitable for construction situations that require amplitude changes. The special connection method of the tower crane's boom sections and the absence of tower heads and tie rods make it very easy and safe to disassemble and assemble the boom section by section. If you need to change the length of the boom during construction, you do not need to dismantle the entire boom, but can do it in the air. It can be written as the increase or decrease of arm joints.
) The boom has good applicability and high utilization rate. The design of the boom facilitates modularization and can give full play to the flexibility and adaptability of the boom.
In addition, the tower crane also adopts three-speed motor speed regulation technology, variable frequency stepless speed regulation technology, two-speed motor drive, etc., which greatly improves the stability and reliability of the equipment.