Trimmer

Trimming machine
Application scope and specifications
The machine is mainly used for trimming around the wire metal mesh. The trimming and trimming diameter is
The size of the trimming mesh is not limited and can be completed with the assistance of auxiliary tooling. , fast cutting speed, flat port, easy to operate.
Instrument model
Machine power
Engine speed
revolution/
minutes
revolution/
minutes
revolution/
Cutting
Maximum cutting diameter
Cutting speed
meters
meters/
Dimensions of the cutter
Length
Width
Height
Length
Width
Height
br/>Length
Width
Height
Weight
The machine is driven by the frame transmission assembly The eccentric mechanism spindle box cutter assembly control component is composed of six major parts.
The driving assembly consists of an AC motor, pulley, and flywheel. It uses a motor to drive the triangle belt to rotate the flywheel at high speed, causing the eccentric mechanism to move within a limited range.
The central machinery is composed of eccentric spindle bearing, bearing, pressure frame, oil seal, cover, spindle and main sleeve. The bearings adopt imported high-quality bearings, and the durability performance is significantly improved. The eccentric spindle rotates through the transmission assembly. While rotating, the eccentric shaft moves up and down, allowing the spindle to move up and down within a limited range. The slider adopts an automatic Lubricated bearings have high wear resistance. After using for a period of time, the gap increases, so you only need to replace this piece.
The box is composed of the main box, box cover, guide base, oil shaft sleeve seal cover. This component is the core part of the machine. Other mechanisms are installed on this box. Before use, lubricating oil needs to be injected into the box to the standard oil mark to effectively ensure good lubrication of the spindle and slider and extend their service life.
The knife assembly is composed of an upper knife holder, a lower knife, an upper knife holder, a knife holder guide column, a knife holder guide sleeve. The spindle of the tool holder adopts a clamping rod. The upper cutting knives are made of high-speed cutting steel, and the lower cutting knives are vacuum processed, which has sufficient hardness, toughness and impact resistance.
When using, pay attention to the gap between the upper cutter and the lower bottom knife. The upper cutter can be adjusted to exceed the lower bottom knife surface.
Troubleshooting
Noise and vibration
Check whether the bearing on the end of the eccentric shaft and the bearing in the eccentric sleeve are damaged.
The frame swings left and right
Check whether the spindle sleeve and tool holder guide column sleeve are excessively worn.