Boyuanjiaheng small softened water equipment

Generally speaking, the operation of boiler softened water equipment goes through five processes: backwashing, regeneration, slow flushing, and fast flushing of produced water. All processes of different types of equipment are very close, but there may be some additional processes due to differences in actual processes or control needs. Any softened water equipment based on sodium ion exchange is developed on the basis of these five processes.
Since solid granular table salt contains a certain amount of impurities, a large amount of impurities will be deposited at the bottom of the salt tank and block the salt valve, so the impurities at the bottom of the salt tank must be cleaned regularly. When cleaning, you can open the drain valve at the bottom of the salt box and rinse it with clean water until no impurities flow out. The cleaning cycle of the salt box should be determined based on the impurity content of the solid granular salt.
Two main technical indicators
Raw water supply pressure
Raw water hardness
/In terms
Dissolved solids
/
Effluent water hardness
/Calculated
Raw water temperature
℃
Ambient water temperature
℃
Water production volume
︿/
Resin tank model
Resin volume
Salt bucket volume
Regeneration salt
Large grains, do not use iodine or calcium salt.
Three Equipment Features
The degree of automation is high. The boiler softened water equipment automatically completes the softening and regeneration cycle processes according to the preset program. Daily operation requires no manual operation except adding salt.
It occupies a small area, the equipment has a compact structure, is compact and lightweight.
It has strong corrosion resistance. The tank is made of fiberglass, engineering plastics or stainless steel to avoid corrosion of the equipment by the regenerant.
Reliable performance and stable water quality.
Flexible selection, single tank, double tank, multi-tank system time flow control mode, simultaneous regeneration, alternate regeneration and other operating modes can be selected according to needs.
Four specifications model
Model
Water production volume
Resin tank size
Resin volume
Salt barrel


< br/>








Points



Size



Height







High







High







High







High







High














< br/>Five types to know
Hourly water consumption unit/
Raw water hardness list/subject to water quality inspection report
Units of potassium and sodium content in raw water shall be subject to water quality inspection report
Outlet water hardness requirement unit/
The best working pressure unit is
Continuous water supply time unit
Ambient temperature and raw water temperature unit ℃
Six installation requirements
No need to specialize Install the foundation, the foundation level is enough
If the inlet water pressure is lower than that, a pipeline pump must be installed.
The pipeline must be flushed before use to avoid impurities clogging the valve body and contaminating the resin.
Do not use iodized salt or calcium salt as a regeneration agent. Add salt to the salt tank regularly to ensure that the saturated concentration of the salt water should ensure that the dissolution time is not less than six hours.
Seven later equipment maintenance
Regularly check the air tightness of the boiler softened water equipment ejector and salt absorption pipeline to prevent air leakage and affect the regeneration effect. The water softener should be disassembled once a year, the impurities in the upper and lower water distributors and quartz sand cushion should be cleaned, and the loss and exchange capacity of the resin should be checked. Seriously aged resin should be replaced. Resins with iron poisoning can be resuscitated with solutions.
Ensure that the voltage and current input to the boiler softened water equipment are stable and prevent the electronic control device from burning out. A sealing cover should be installed outside the electronic control device to prevent moisture and flooding. Add solid granular salt to the salt box regularly, and ensure that the salt solution in the salt box is in a supersaturated state. When adding salt, be careful not to sprinkle solid granular salt into the salt well to prevent salt bridges from forming on the salt valve and blocking the salt suction pipeline.