Things to note during the construction process of door and window installation projects—benchmark construction

Precautions during the construction process of door and window installation projects. Baseline construction
The installed doors and windows are beautiful and practical. During the construction process, you must pay attention to some small details. Here are some precautions for the construction of doors and windows. .
Attention: horizontal and vertical are very important
The installation of door and window covers is the most commonly used method for door and window renovation in home decoration. During the construction of door and window covers, holes should be drilled in the base wall first and the mold should be lowered. The distance between the top and bottom of the mold is less than millimeters, and the distance between each row is less than millimeters. The moldings should be horizontally and vertically. If the base wall is not vertical, use spacers to make the foundation vertical first. Then cut the large core board according to the designed door and window facing width and doorway width, and fix it on the wall and door opening with round nails. The round nails should be nailed to the mold.
Attention point 2: The firmness of the bottom pad
After checking that the bottom pad is firm and safe, it should be painted with fire-retardant paint. Because the characteristics of doors and windows are good sealing, fire prevention and wind protection.
Note three: Do not damage the appearance
Door and window cladding panels should choose plywood with beautiful patterns and smooth surfaces. The tree species of the plywood should meet the design requirements. When cutting the decorative panel, you should first pop up the cutting line according to the width of the door opening and the face, cut it with a sharp knife, and plan the seams. At the corner, apply latex on the back and stick it to the base plate. Use a nail gun to drive uncapped straight nails into the surface for reinforcement.
Note that the joints in point 4 must be straight
Note that the joints at the door opening and wall interface must be straight and angled. After the decorative panel is pasted and installed, seal the edge with a corner line and plan the horizontal and vertical joints of the corner line. Corner seam treatment.
Things to note during the construction process of door and window installation projects. Baseline construction