Gear processing methods, gears, gear hobbing machines, gear processing machine tools, gear processing modules

In Yongtao gear processing, there are mechanical elements on the gear rim that can continuously mesh and transmit motion and power. Gears are mechanical parts with teeth that can mesh with each other. The application of gears in transmission has appeared very early. At the end of the century, the principle of the generated gear cutting method and the special machine tools and tools that use this principle to cut gears appeared one after another. With the development of production, the smoothness of gear operation has received attention.
Gears are made of wood or cast from metal. They can only transmit the rotary motion between shafts and cannot ensure the smoothness of the transmission. The load-bearing capacity of the gears is also very small.
The application of gears in transmission appeared very early. In more than 300 BC, the ancient Greek philosopher Aristotle elaborated on the problem of using bronze or cast iron gears to transmit rotational motion in "Mechanical Problems". A complete set of wheel trains has been used in the compass invented in ancient China. However, ancient gears were made of wood or cast from metal, which could only transmit the rotational motion between shafts and could not ensure the smoothness of the transmission. The load-bearing capacity of the gears was also very small.