Precautions when using industrial waste gas treatment equipment

The emergence of industrial waste gas treatment equipment not only helps factories deal with waste gas, but also protects the environment in which we live. The following is a summary of the precautions when using industrial waste gas treatment equipment. I hope it will be helpful to everyone.
1. Before using industrial waste gas treatment equipment, you should check whether the pipes and valves of each system of the equipment are intact, and whether the selection and proportion of the absorbent liquid agents are correct. If the absorbent liquid does not meet the specified requirements, it needs to be replenished in time. When starting up, the water pump should be turned on for a few minutes before turning on the fan. When shutting down this purification system, you should first turn off the fan for a few minutes and then turn off the water pump. Do not turn it on randomly, otherwise it will burn out the motor, block the filler, and affect the purification effect.
2. The wiring of the fan and water pump of the industrial waste gas treatment equipment must not be tampered with. It must be absolutely ensured that their rotation is correct and must not be reversed. Otherwise, the motor will be damaged and an accident may occur.
3. After the industrial waste treatment equipment is delivered for operation, the user unit should assign dedicated personnel to keep it for use and conduct regular inspections. If any abnormal noise or water leakage is found in the equipment, it should be shut down and repaired before use.
4. Industrial waste gas treatment equipment is installed outdoors, and a rainproof cover should be made for the water pump and fan motor to prevent the motor from getting damp. Whether industrial waste gas treatment equipment is installed indoors or outdoors, if fiberglass or plastic fans are used, a protective cover must be installed to prevent loosening of screws, damage to the bearings, inhalation of debris, or damage to the impeller when the impeller explodes and injures people, causing accidents.
5. Replacement and use of purification liquid in industrial waste gas treatment equipment. The formula ratio of the purification absorption liquid is determined according to the different gas sources and concentrations of the user units. The details will be provided after the equipment is debugged and accepted normally. Report to user administrator.
Only if we pay careful attention during use can it serve us better and extend the life of the equipment.