Year1
- 型号：
- CUT-100
- 品名：
- 九圣等离子电源
- 规格：
- 70×32×61
Series technical specification parameter list
> Name
Technical parameters
Rated input voltage
Rated input current
DC no-load voltage
DC working voltage
DC working current
Duty duty rate
Calculation cycle
Input air pressure
Air flow
Overall dimensions length, width and height
Whole Machine weight
Host power supply
The main power supply of this equipment is a current stepless adjustable structure.
Hand Cutting Torch
Our company's hand cutting torch is mainly used for cutting straight lines, curves, arcs, etc. in small batches in situations where processing requirements are not high. The specific principle of selecting a cutting torch model is to satisfy both cutting quality and economy. For example, when the cutting thickness is thin, a set of small cutting torches can be purchased to obtain a much narrower cutting kerf, increase the cutting speed, and save cutting costs. cost.
Mechanical cutting torch
The machine cutting torch selected for this machine is a patented cutting torch independently developed by our company. It has the characteristics of high cutting efficiency and smooth vertical cutting surface. However, machine cutting torches cannot work in direct contact with the workpiece. Air source
If you use compressed air (whether it is air pump compressed air or pipeline compressed air), you must ensure that the output gas is dry, oil-free and clean. If this requirement cannot be met, a filtration and purification device must be installed before inputting into the equipment. And requirements Enter the pressure range of the host machine, otherwise it will not work properly. The pressure value of the gas pressure reducer on the rear panel of the main power supply must correspond to the machine standard. If the pressure is too high or too low, the normal and ideal cutting effect will not be achieved. (It is recommended to select the pressure flow rate. /㏕ compressed air pump)
Nitrogen source
When you use nitrogen as the plasma carrier gas, you must pay attention to the purity that must be reached before it can be used. The input pressure range also needs to be between, otherwise it will not work properly.
Oxygen source
When you use this equipment to cut low carbon steel, you can special order a model that uses oxygen as the plasma carrier gas to improve cutting efficiency. However, please pay special attention to the fact that oxygen supports combustion and there should be no flammable or flammable materials around it. Explosives or gases to prevent accidents. Note that although using oxygen as the plasma carrier gas can improve the cutting efficiency of mild steel, the service life of the electrode is reduced.
Additional gas filter
When the input When the compressed air contains moisture or oil, it cannot be filtered by the gas filter inside the host power supply alone. It is recommended to add an external air-water filter. If the single-stage filter cannot be filtered, three-stage filtration can be used and connected in series one by one to ensure input The air is dry and clean.
WhatsApp
