Heating car boiler|Model XXJRQ16.3Q|Voltage DC24V

型号：

16.3Q

工作电压：

24V

电流：

2.5A

The manufacturer of forced water heating and warm air automobile boilers provides more detailed information about diesel automobile boilers. De'an Security Automobile Boilers and automobile fuel heaters are seasonal equipment. Corresponding inspections and maintenance should be done before use, during use and after shutdown to ensure Safe and reliable to use. The following items must be checked and maintained during secondary maintenance. The liquid heater should be turned on once a month when it is not in use.
Check the fuel filter and replace it if necessary
Check the sealing of the water pipe and whether there are bends and Interference part
Check the sealing of the fuel pipeline and whether there is oil leakage
Check whether the circuit is damaged, whether the connector is loose, and whether the fixation is reliable
Check whether the water pump motor is running normally and whether there is any abnormal noise
Check whether there is carbon deposits on the glow plug or ignition generator (ignition electrode)
Check whether each sensor is valid
Check the combustion air and exhaust pipelines to ensure that the smoke exhaust is smooth and unblocked
Check whether the radiator and defroster fans make any abnormal noise or get stuck
Whether the radiator tank is leaking[]
Ensure that the oil tank, oil pipe and oil filter solenoid valve are clean to prevent dirt from clogging the oil circuit
Usage precautions Note: Vehicle liquid fuel heaters can only use diesel as fuel. (Diesel gas is required, please specify)
Be sure to open the pipeline valve before using the heater to ensure that the liquid in the pipeline can circulate, and at the same time fill it with antifreeze, otherwise the dry grinding of the water pump will produce high temperatures , causing damage to the water seal components.
It is strictly prohibited to use the vehicle's main power switch to turn off the heater to prevent overheating and damage to the main unit.
The coolant medium filled in the circulation system must be antifreeze, which meets the temperature requirements of the vehicle's operating environment and prevents the radiator from rusting and scaling.
When filling the circulating system with coolant medium, you must first open the heater bleed plug (on the heater inlet pipe) and the pipeline bleed valve. Wait for the bleed valve, especially the heater bleed plug. When there is no gas coming out, close the bleed plug (bleed valve, turn on the water pump switch, and continue filling until the circulation system is filled with coolant medium.