Installation of color steel plates for double large computer rooms in Beijing | Production of color steel plates

规格：

1200*2600mm

Methods and precautions for installing color steel plates in Beijing's double large computer rooms
1. Installing color steel plates in Beijing's double large computer rooms requires the following tools/raw materials
Computer room color steel plates, male corner pieces, female corner pieces, fasteners, and pressure strips Type light steel keel, screws, rivets.
2. Steps/methods for installing color steel plates in machine rooms in Beijing Shuangda University
Set out according to the drawings and the actual dimensions measured on site (note that the center line of the partition wall pops up at the intersection of the center line of the two closed edges and the ground The center line of the ground rail. Remember to make sure that these four lines are in a vertical plane to ensure that the wall surface to be installed in the future is vertical.
The sky rail is fixed to the cement ceiling with nails or screws every other time. Installation requirements Neat, and the interfaces must be reinforced and repaired.
Before installing the ground rail, reserve the installation position for the door, and pay attention to the height difference between the ground. If the difference between the height of the ground is too large, it must be leveled to reduce the gap without affecting the Adjust the level and fix the floor with nails or screws every other time. If the ground seam is too large, fill it with caulking agent.
, edge closing is to ensure that the closing edges are neat and consistent, and there are no gaps in the joints. It should be based on actual measurements It is worth cutting and trimming, and the edges should be trimmed evenly after cutting. When trimming, pay attention to the interface with the sky rail and skirting board to ensure there is no gap.
Vertical keels should be spaced every other (half the size of the partition) Install a vertical keel. The columns on both sides of the door frame are completely fixed up and down without shaking. Add a vertical keel in the opposite direction. The width of the door leaf is required to exceed the above. The horizontal columns on the door frame must be strengthened and fixed. If necessary, fix them Welding and fixing.
. The transverse through-core keel is required to be higher than one meter in height, and one should be placed in the vertical direction. When the two connected joints must overlap, the overlap length must not be less than.
. The wall panels should be constructed in order. Begin to install the color steel plate on one side, and the distance between the connected plates is. Use wide battens between the partitions, and the standard unit wall panels are interchangeable
3. Precautions for installing the color steel plate
When installing the wall Pay more attention to details when installing the board. First, use a pallet truck to transport the wall panel to the vicinity of the installation point. Then use a suction cup to hold the metal panel upright so that its lower end rests on the skirting board. Both sides of the lining board are close to the vertical keel, and one side is in contact with the vertical keel. Use fixings to fix the spacing between the other wall panels. Then fix the self-tapping screws to the vertical keels. The fixed spacing is in between. Pay attention to the horizontal and vertical directions when assembling. When it comes to the last wall panel, if it needs to be cut, When doing this, you must measure the size, then cut and trim it in the correct way, and install it on the wall.
Use shaped inner corner strips to close the corners of the wall.
/> , Factory-tailored fixed-length color steel plates can be used on the corners and columns to achieve a beautiful and elegant overall effect.
, In order to keep the corners consistent with the wall, the corners of the wall are professionally edged with the same color.< br/>