Large supply of high temperature resistant paint 500 degrees 600 degrees silver powder high temperature resistant paint

High-temperature resistant paint | High-temperature silver powder high-temperature resistant paint | High-temperature-resistant paint | High-temperature-resistant paint quality standards | Ultra-low-price high-temperature-resistant paint | High-temperature-resistant paint manufacturers supply most of the silicone high-temperature resistant paints produced by general manufacturers , and as a manufacturer specializing in the production of high-temperature resistant paint, we have high-quality products, our prices are the lowest on the Internet, and our quality meets our technical standards.
It is the paint manufacturer of your choice for purchasing.
Construction Reference and Supporting Requirements Mix components A and B evenly before use.
The coating method is conventional air spraying or airless spraying.
Installation interval hours ℃ above hours / below ℃.
Coating dosage
The dry film thickness is about microns (one pass)
The diluent is a matching special diluent.
Surface treatment grade (sandblasting).
Storage period: months. After this period, it can still be used after passing the inspection.
Construction Reference
The basic surface of pre-treatment should be sandblasted (especially above ℃). The sandblasting grade is up to grade, that is, there is no oil rust on the surface of the base body and has a uniform roughness. Below ℃, mechanical rust removal can be used. Level is enough.
Conventional air spray pressure is used for coating
The viscosity of the paint is adjusted in seconds with a special diluent
The dry film thickness is sprayed in two sprays with an interval of minutes.
After drying and spraying, dry at room temperature for an hour and then bake at about ℃ for a few minutes. Or after the coating is completed, it can be put into use after drying at room temperature for more than a few days.
It shows that if there are higher requirements for the corrosion resistance of the coating (salt spray test hours and above), it can be matched with anti-corrosion primer, and the effect will be more ideal.
The hardness of the paint film after drying at room temperature is not as high as that of two-component resin paints (such as epoxy acrylic, etc.), but after a period of high temperature use, the hardness and strength of the paint film will gradually increase.
Customers with a large purchase volume at one time can get discounted prices and free shipping
Contact phone number Contact Manager Li