Generator control part troubleshooting

Troubleshooting of the generator control part
For the manually controlled unit, when the key is turned, the unit does not start or the LCD module controls the unit and the unit does not start when the unit start button is pressed
Check the key switch Whether the operation is good and correct or whether there is output from the module startup port
Check whether there is a fault indication, repair the fault if necessary, and reset the corresponding fault information
Check the battery voltage. If the voltage is too low, the battery needs to be re-checked. After charging to full, if the voltage value is normal, you need to check step by step according to the drawing whether the voltage signal is correctly sent to all control links, such as the throttle solenoid valve and starter motor, etc.
Check whether the emergency stop button has been relaxed
Is the relay in good condition
Service hotline No., Xinghuo Road, Xi'an (No. Zhuhong Road Tianzheng Mechanical and Electrical Market Area)