Shandong Jimo Garment Factory Steam Vortex Flowmeter 0532-67731337

型号：

XBOLUGB

压力：

1.6

Shandong Jimo Garment Factory Steam Vortex Flowmeter
Qingdao Xinbo Instrument Co., Ltd. Sales Hotline
/
Contact Fang Xiaoyan
Welcome to call for inquiries
Qingdao Xinbo Steam Flow meter, vortex flowmeter, battery-powered flowmeter, high-temperature flowmeter, high-pressure flowmeter, high-precision vortex flowmeter, special flowmeter for ton boilers, remote transmission vortex flowmeter, laboratory gas flowmeter , Vortex steam flowmeter
Vortex flowmeter
Vortex flowmeter can measure gas, liquid, and steam. It is especially suitable for measuring steam, such as boiler steam. Vortex flow meters are mostly used for power plant steam. It can be seen that the vortex flowmeter is the first choice flowmeter for measuring steam
Vortex flowmeter measurement mechanism
Liquid cold water, hot water, various oils, liquefied petroleum gas, various chemical liquids and oils
Gas compressed air Oxygen, natural gas, petroleum gas and various chemical gases
Vortex flowmeter is a volume flowmeter that measures the volume flow rate or mass flow rate of gas, steam or liquid based on the Karman vortex principle. It can also be used as a flow transmitter in automated control systems for system integration.
With the development of remote monitoring systems, vortex flowmeters are also used in wireless remote monitoring systems. Meters can be read without leaving home, which greatly improves efficiency.
The shortcomings of the vortex flowmeter are the higher requirements for the front and rear straight pipe sections. If the site conditions do not allow it and the straight pipe section cannot be reserved, it is best to re-select the model and use
cone flowmeter or orifice flowmeter. plate flow meter. These two flowmeters have lower requirements for straight pipe sections and are more accurate.
The vortex flow sensor cannot be installed in places with large temperature changes or subject to heat radiation from equipment. If it must be installed, heat insulation and ventilation measures must be taken.
The sensor cannot be installed in an environment containing corrosive gases.
The vortex flow sensor cannot be installed on the pipeline close to the air compressor. The vibration of the pipeline will have a greater impact on the flow meter data. In this case, change the location where the flow meter is installed to be as far away from the air compressor as possible.
The vortex flowmeter can be installed horizontally or vertically on the pipeline, provided that the measured medium flows through the entire pipe. When installed vertically, the direction of the fluid should be from bottom to top.