Visible light photocatalyst nano titanium dioxide purifies the air

型号：

JR05

粒径nm：

5

含量%：

99.99

Basic information:
#:
Properties:
< >Particle size is very small: the particle size is smaller than nanometers and does not agglomerate.
< >Good dispersion performance: This nanometer titanium dioxide has very good dispersion performance. Put it into water and shake it gently, and it will immediately melt into a transparent liquid without stirring. It can be sprayed onto furniture surfaces and walls to form a uniform and transparent nano-coating, which can purify indoor air.
< >High catalytic activity: The catalytic activity of this nanometer titanium dioxide has been tested and compared, and it is twice as high as the catalytic activity of all the nanometer titanium dioxide with the best catalytic performance on the market. It can quickly capture and decompose indoor formaldehyde, benzene, ammonia and other harmful gases, and has a good deodorizing effect.
< >b>Technical indicators
:

< R

< Powder Appearance
< White Powder

< Appearance of Powder Dissolved in Water
< Transparent Liquid

< Particle Size
<

< Purity
< .%

< Surface Properties
< Hydrophilic


Usage
: Use distilled water, deionized water, etc. to make R powder into an aqueous solution with a solid content of Formaldehyde indicators and odor indicators are both up to standard. If the smell is strong, you can spray it twice more. (It is recommended to use a clean towel dipped in water to gently and evenly wipe the inside and outside of the furniture. The first towel should be wet, and the second towel should be dry. The same is true for the floor, or use a clean mop to mop evenly)
Note Matters
:
,
It is generally recommended to use a good quality towel soaked in water to wipe the inside and outside of the furniture (the concentration of the aqueous solution is %). It is recommended not to spray the metal surface
,
Start ventilating after spraying. If there are a lot of indoor furniture, formaldehyde will evaporate faster and the concentration will be higher. It is recommended to spray several times more to increase the degradation rate.
When spraying, generally use a paint spray gun, which has a good atomization effect, which will spray more evenly and improve efficiency.
Before spraying, clean the surface to be painted, cover the objects that are not suitable for spraying, and keep the distance between the spray gun and the object to be coated cm.
. The natural drying time of the coating is about minutes, and it takes hours to fully cure. Do not scrub vigorously before it is completely cured.
. When used for sewage treatment, first dissolve R with a small amount of pure water, and then add sewage middle. It is recommended to take the water behind the secondary sedimentation tank and in front of the biochemical tank. The water with better transparency will have more obvious treatment effect. It is more suitable to treat the sewage after inorganic sedimentation treatment. The dosage is about R powder for one cubic meter of sewage.
Packaging
Packaging
: bag or barrel.