Ultrasonic cleaning equipment maintenance, ultrasonic cleaning machine maintenance knowledge

Ultrasonic cleaning equipment maintenance, ultrasonic cleaning machine maintenance knowledge
What to do if the ultrasonic cleaning machine is broken, how to repair it? During the use of the ultrasonic cleaning machine, some problems may occur. So what are the problems with ultrasonic cleaning machines?
The transducer of ultrasonic cleaning machines gets damp.
Generally, you can use a megohmmeter to check the plug connected to the transducer and check the insulation resistance value between the positive and negative poles of the transducer. Generally, the insulation resistance is required to be greater than megohms. If this insulation resistance value cannot be reached, it is likely that the transducer is damp. The maintenance method is to put the entire transducer (excluding the plastic spray shell) into the oven at about the desired setting, and dry it for three hours or use a hair dryer to remove moisture until the resistance value is normal.
.The transducer vibrator of the ultrasonic cleaning machine ignited and the ceramic material shattered.
During maintenance, you can use a combination of visual inspection and megohmmeter. Generally, as an emergency measure, individual damaged transducers can be disconnected without affecting the normal use of other transducers.
.Ultrasonic cleaning machine transducer degumming.
We know that most manufacturers use glue to fix the transducer, but after long-term use of the ultrasonic cleaning machine, degumming will occur due to vibration. Some manufacturers also adopt the method of cementing and screw fastening. Generally, degumming will not occur. Due to the role of the screws, the vibrator will not fall from the vibrating surface after being degummed. The general method of judgment is to gently shake the tail of the vibrator with your hand and carefully observe the vibration. Make a judgment based on the glue condition on the surface.
.Ultrasonic cleaning machine vibrator degumming.
Generally, after the vibrator of an ultrasonic cleaning machine is degummed, the output power of the ultrasonic power supply is normal. However, due to the poor connection between the vibrator and the vibrating surface, the vibration effect of the vibrating surface is not good. After a long time, the energy cannot be released, and it is likely to burn. Bad vibrator. The degumming of the vibrator is troublesome for users to repair. Generally, they can only be sent back to the manufacturer for repair. The most effective way to avoid vibrator degumming is to be careful not to hit the vibrating surface during daily use.
.The vibration surface of the ultrasonic cleaning machine is perforated.
Generally, after using an ultrasonic transducer at full load for several years, perforations on the vibrating surface may occur. This is due to the fatigue of the stainless steel plate on the vibrating surface due to long-term high-frequency vibration. Perforation on the vibrating surface indicates the use of the transducer. The service life has expired, and maintenance is generally limited to replacement.
Professional maintenance phone number for ultrasonic cleaning machines and ultrasonic cleaning equipment:
< >Tel number: