Liuzhou Xinle washing machine after-sales maintenance "Wash cleaner"

Liuzhou Xinle washing machine after-sales repair "Wash cleaner"
Liuzhou Xinle washing machine after-sales repair hotline ***** hourly repair hotline
Repair the washing machine for leakage
The washing machine is wet If the internal electrical components or wiring of the washing machine are damaged or soaked by water, the insulation of the washing machine to the ground will be damaged, causing the voltage to be directly connected to the ground, causing leakage. In addition, static electricity Inductive electricity also often occurs. Therefore, once electrification is found, the machine should be shut down and powered off, and it should be checked by a professional.
The liquid in the barrel is charged. This is mostly caused by the connection between the pulsator shaft and the live parts. You should focus on checking the insulation condition and water leakage of the electrical components under the barrel until the fault is eliminated.
, the shell is charged. When the casing is live, check whether the power cord is damaged or the copper wire is exposed. After detecting the leakage part, it should be wrapped with insulating tape.
If the capacitor itself is damaged, the capacitor should be replaced.
, electromagnetic induction phenomenon causes induced electricity. At this time, even if the insulation of the washing machine is very good, the glow phenomenon can be measured with a test pen. Usually the energy of induced electricity
is small and will not cause harm to personal safety. The methods to eliminate induced electricity are as follows: first, connect the ground wire of the washing machine; second, swap the power ground hole
and insert the original one. Insert the ground wire hole into the live wire hole instead.
Static electricity is the result of strong electrostatic induction in the washing machine. The energy is relatively large. In severe cases, it will give people a strong electric shock. There are two ways to eliminate static electricity. One is to replace the belt or pulley. The other is to immerse the belt in clean water. Soak for about an hour, take it out, dry it, and reinstall it.
Warm reminder: If your washing machine has leakage, please call the after-sales customer service hotline, and please do not let your children
get close to avoid injury!
Liuzhou Xinle washing machine after-sales repair hotline