Super strong permanent magnet

We are Chenzhou Qitian Magnet, the only company in Hunan that specializes in the production of iron removers for conveyor belts in brick factories. Our factory's suspended iron removers have strong suction and can suck up the teeth of excavators, and can remove large iron under very thick materials. Suck it out to protect the brick making machine and coal pulverizer. Welcome to Chenzhou for visit and inspection. The factory is located at Feihong Steel Market, Xiameiqiao, Chenzhou City. The correct selection should be based on the requirements of the miscellaneous removal rate, the iron content of the material, the on-site working environment, etc. Iron remover. .When the material layer is thick and the particle size of the material is large, it is advisable to use a super strong magnetic iron remover or a larger one-stage or two-stage super model. An ordinary iron remover can also be used. Multi-stage iron removal should be installed as much as possible with an iron remover. Used on belt conveyor head. .When the requirements for the removal rate of miscellaneous iron are high, iron removal equipment with different working modes can also be used together. For example, a permanent magnet roller is used at the head of the belt conveyor, and a belt-type iron remover is used in the middle of the belt conveyor. .When the on-site environment is very dusty, a fully enclosed iron remover should be used. .When the power capacity is insufficient, a permanent magnet iron remover should be used. .When the material contains a lot of impurity iron, a self-unloading iron remover should be used. . When the iron remover is installed on the head of the belt conveyor, due to the inertial force of the material, it is in a loose state when leaving the belt, which is conducive to iron removal. If the drive of the belt conveyor head is changed to be made of non-magnetic material, the iron removal effect will be better. . When an iron remover is installed in the middle of the belt conveyor to remove iron, the rollers under the iron remover can be changed to non-magnetic flat rollers, which can further improve the iron removal effect. . When using multi-stage iron removal, the iron removal suction of the subsequent stage should be higher than the iron removal suction of the previous stage, otherwise, the iron removal effect will be reduced. , It is recommended to use a belt-type permanent magnet iron remover for the belt conveyor bandwidth below, and an electromagnetic iron remover for the belt conveyor bandwidth above. , When the on-site environment is special and the situation is complex, we will make special designs for users to meet the actual working conditions. The hanging device of the iron remover should be selected according to the actual needs of the on-site working environment, and the purchase should be made after measuring the hanging position and environmental conditions of the iron remover.