ADSS optical cable-ADSS suspension clamp

材质：

热镀锌

长度：

1800

破断力：

70KN

Suspension wire clamp Suspension wire clamp includes type ring, right-angle hanging ring, cast aluminum casing, rubber clamp block, inner twisted wire and outer twisted wire. It should be able to withstand the vertical load of the optical cable, and the cable clamp itself should not cause damage that causes stress concentration.
Pre-twisted suspension clamps for optical cables
Composition: inner twisted wire, outer twisted wire, suspension components and connecting hardware, etc.
Purpose: It plays a supporting role to suspend the all-dielectric self-supporting optical cable () on the pole tower with a smaller line angle.
> Features:
. The suspension clamp has a large contact area with the optical cable, the stress is evenly distributed, and there are no stress concentration points. At the same time, the stiffness of the optical cable at the hanging point is enhanced, providing better protection. .
b. It has good dynamic stress tolerance and can provide sufficient gripping force to protect the safe operation of optical cables under unbalanced load conditions.
.The structure is equipped with flexible rubber clamps to enhance self-damping and reduce wear.
.The ends are rounded to increase the corona initiation voltage.
.High-quality aluminum alloy material improves the mechanical properties and anti-corrosion performance of the clamp, greatly extending its service life.
Ordering instructions:
.Select the appropriate suspension clamp according to the operating distance, outer diameter, ultimate tensile strength and other parameters of the optical cable.
b. The quantity configuration is as follows: the set of poles with a line angle smaller than that of the tower.
.In order to meet the needs of erecting optical cables on urban network distribution lines, our company has developed and produced suspension clamps suitable for one meter pitch. It has a simple structure, is easy to install, and can reduce project costs.