German Schenck single-channel vibration controller VC-920

b br >Vibration controller
: ' R', rb br >
: b br > is an instrument used to measure, monitor and display the vibration of bearings and housings. The current measured value is regarded as the effective value of the vibration speed
: ' R', rb br >,
: b br >
: ' R', rb br >
: b br >The unit
: 'R', rb br>,
: b br >The size can be read directly from the instrument that displays three digits. Vibration on the vibration controller
: ' R', rb br >,
: b br > is connected according to the standard
: ' R', rb br >,
: b br > speed sensor. Through the integration method
: ' R', rb br >,
: b br > When the vibration acceleration sensor is put into use
: ' R', rb br >,
: b br >Complete the transition to the corresponding vibration speed value. In order to signal an exceeded measured value
: ' R', rb br >,
: b br > two adjustable limit values are provided that exceed the total range. Based on a short-time exceeding of a limit value
: ' R', rb br >,
: b br > a response delay can be activated for each machine limit
: ' R', rb br > ,
: b br >In order to prevent the occurrence of fault signals. Destruction limit values are displayed on the vibration monitor
: ' R', rb br >
: b br > via LEDs
: ' R', rb br >,
: b br >The output of the same diode is completed through their respective potential conversion contacts. Parameters are used to match the measurement and monitoring tasks calibrated on the instrument. The diagnostic outputs are provided for control purposes. Phase correctly taps the input onto this output. Screw terminal clamps guide all connections to the instrument.
:: R, #.: