Year1
- 型号：
- SL4.0
- 功率：
- 7.5kw
- 产量：
- 4吨
1. Purpose of straw kneading machine
The straw kneading machine can knead corn straw, sorghum straw, bean straw and other crop straws into softer rod-shaped feed, which is suitable for small feed factories and straw briquetting machines for biomass It is solidified into rows and used by cattle, sheep and horse farmers.
2. The structure and technical parameters of the straw kneading machine
The straw kneading machine is mainly composed of a feeding port, a hammer, a tooth plate, a fan, a discharge port, a motor and a frame.
Technical parameters
Model: .Model:
Supported power: .～kW Supported power: .～kW
Spindle speed: rev/min Spindle speed: rev/min
Rotor working diameter: Rotor working diameter:
Production efficiency: ~ / Production efficiency: ~
Forage length: ~ Forage length: ~
Throwing distance: ~ Throwing distance: ~
Overall dimensions: ** Overall dimensions: **
(The above parameters are for reference only and will be changed without prior notice)
3. Use of straw kneading machine
Straw Installation of kneading machine
Use bolts to firmly install the kneading machine and motor on the machine base. Adjust the position of the motor to ensure that the motor pulley groove and the main machine pulley groove are aligned and the appropriate belt tightness is obtained. Place the base and machine on a flat cement floor.
All electrical equipment and wiring must be connected safely and reliably.
After installation, all parts of the machine can operate flexibly, and can be put into use only after running without any jamming or collision.
. Operating points of the straw kneading machine:
When the machine is operating, the material is manually placed into the feeding port, and is fed under the action of the pressure roller at the feeding port, the high-speed rotating blade and hammer, and the action of airflow. When it enters the working room, it is kneaded into loose feed by the hammer blades and toothed plates, and then thrown out of the body by the fan.
Before starting the machine, check the connection status of all parts, remove debris and stones in the machine and in the material to be crushed, then start the machine, and wait until the machine operates normally before formal operation. During work, operators should feed materials continuously, evenly and without interruption. If there is a blockage due to too many people being fed or the machine makes abnormal noises, stop immediately and troubleshoot. After the work is completed, the power supply should be cut off first, and then the machine should be wiped and the site should be cleaned.
WhatsApp
