Manufacturer's first-hand supply bucket elevator

the position of the hopper on the traction part should be correct and fastened reliably. During operation, there should be no deflection or collision with the casing.
', After the spiral tensioning device is adjusted, the traction member should have uniform tension necessary for normal operation. In order to have sufficient tightening stroke during operation, the remaining tightening stroke should be no less than the full stroke.
', The axis of the high-speed shaft of the reducer and the axis of the motor should be parallel to each other. The axis of the low-speed shaft and the axis of the bucket elevator drive shaft should be on the same horizontal line, and their maximum parallel offset shall not exceed., the maximum The intersection angle of the axes shall not exceed ‵.
' , the bucket elevator should be equipped with lifting equipment, and the lifting capacity should not be less than. The distance between the rail bottom of the crane and the drive center line is generally ~.
' ,
' ,
' , Xinxiang Weiyuan Chemical New Technology Co., Ltd.
' , Ding Rongwei
' , Tel:
' , Email: [r]