Guihe supplies pile drivers, high-quality pile driver manufacturers

型号：

打桩机

Pile Driver - Pile Driver Classification and Working Principle Steam Hammer Pile Driver. High-pressure steam is used to lift the hammer head, and then the hammer head impacts the pile head downwards by its own weight, causing the pile to sink into the ground.
Diesel hammer pile driver. It uses fuel explosion to push the piston, and uses the explosive force to impact the pile head, causing the pile to sink into the ground. It is suitable for driving all kinds of prefabricated piles.
Vibratory hammer pile driver. The mechanical vibration force of the pile hammer is used to sink the piles into the ground. It is suitable for bearing small precast concrete piles, steel sheet piles, etc.
Static pile driver. The pressure generated by a mechanical winch or hydraulic system is used to press the piles into the soil under the action of continuous static pressure. It is used for various types of prefabricated piles with general bearing capacity.
Pile driver - installation operating procedures
1. Pile driver operators must be familiar with the structure, performance, operation essentials and safety precautions of the machine. They can only operate alone after passing the examination and obtaining the certificate. .
2. Operators must concentrate when operating. Do not talk, laugh, fight or make trouble with unrelated persons. Smoking and eating food are not allowed during operation.
3. Strictly abide by the relevant maintenance regulations of the pile driver and carefully perform maintenance at all levels to ensure that the pile driver is always in good condition. And pay attention to reasonable use and correct operation.
4. Before the pile driver starts working, the following preparations should be made:
1. Understand the construction conditions and tasks from the construction personnel, as well as the problems found during the construction and matters that the class should pay attention to.
. Adjust the position of the pile driver's transmission gear according to the vibration force required by the construction personnel.
Check whether the insulation of cables and wires is good. Check whether the controller contacts are in good condition and whether the limits are correct.
Check whether the voltage of the power supply meets the requirements.
Lubricate and maintain each part according to daily maintenance items.