[Hot air drying oven] Drying hot air oven supply||Hot air drying oven price

[Hot air drying furnace] Drying hot air furnace supply||Hot air drying furnace price is made of a rotary heating device and consists of a combustion chamber, a heat energy conversion chamber, a steam generating device, a combustion-supporting device, a fan, a chimney and other parts. High efficiency and energy saving, high thermal energy conversion rate. .The fuel required for burning is wood chips, wood chips, coal, etc. .Adopt a steam generating device with unique functions to ensure that sufficient steam is supplied to the drying kiln. In the early stage of drying, a large amount of steam enters the room, increasing the indoor humidity to prevent the wood from deforming and drying out. .Drying wood has the characteristics of short drying cycle, low cost, uniform drying and good effect. It solves the defects such as internal cracking, fracture, surface cracking, deformation and discoloration that occur during the drying process of wood. .It can be designed according to the requirements so that one furnace can be equipped with two drying rooms to facilitate alternate operations. .It can be combined with the original earth kiln for technical transformation to save equipment investment. .The overall equipment is easy to operate, safe and reliable. .This equipment is suitable for drying all kinds of wood. It is an ideal replacement product for furniture factories and wood products factories, home-made drying kilns and old drying equipment. Working principle of the equipment The hot air (steam) horizontal circulation wood drying kiln consists of two parts: a combustion device and a drying kiln. The working principle of hot air drying equipment is to use the heat energy generated by combustion to heat the air in the kiln. The main fan on the top of the hot air furnace sucks the air in the kiln into the furnace body through the pipe to heat the air. Then it is sent into the kiln through the pipeline, and the circulating fan in the kiln continuously circulates to evenly heat the wood in the kiln. If steam is needed during the wood drying process, it can be provided by the steam generator in the hot blast furnace. If there are two or more rooms in one furnace, a plug valve is installed on the pipe, and the temperature in the kiln is controlled by adjusting the plug valve. During the drying process, since the wood needs to be dehumidified, there are dehumidification holes on the top of the kiln.