Huangming flagship store) Liuzhou Huangming solar water heater repair phone number

Huangming flagship store) Liuzhou Huangming solar water heater repair phone number
Liuzhou Huangming solar water heater repair phone number: -
Huangming maintenance: -
Failure, safety valve small hole outflow
Reason: The tap water pressure is too high, exceeding... (safety valve relief pressure). (Treatment method: Install a pressure reducing device in front of the water heater inlet or open the water outlet) The steam pressure in the heater is greater than the pressure relief pressure of the safety valve, and a small amount of water comes out. (Treatment method: This is a normal phenomenon) The thermostat is broken, causing the water heater to be in a heating state. (Method: Replace the thermostat)

The fault and leakage protection indicator light does not light up
Reason: The power pole base has no power or poor contact. Treatment: Use an electric pen to check whether there is electricity and whether the contact between the leakage protection plug and the socket is good.
Cause: There is no water in the water heater (or it is not filled), the electric heating tube is in a dry burning state, and the reset button of the leakage protection plug jumps and cuts off the power supply. Treatment: First fill the water heater with water according to the instructions for use, and then press the reset button of the leakage protection plug, even if it can return to normal.
The reason is that the water temperature of the water heater is too high, and the reset button of the leakage protection plug jumps and cuts off the power supply. Solution: The thermostat fails, replace the thermostat.
The solar water heater leaks electricity. The reset button of the leakage protection plug jumps and cuts off the power supply. Treatment: Use an electric pen to check whether there is leakage. If there is leakage, use an electric pen to identify the location of the leakage and try to eliminate the leakage.