Fully automatic hydraulic trimming machine

Supply of fully automatic hydraulic trimming machine manufacturers customized hydraulic trimming machine professional design manufacturers direct sales hydraulic trimming machine, aluminum-magnesium product edge punching machine, die-casting edge trimming machine:
Suitable for aluminum-magnesium product edge trimming machine Scope:
This series of hydraulic presses are used for burr punching of various types of aluminum and magnesium alloy die-casting products, trimming of plastic products
, shaping of various metal products, secondary pressing and shaping of motor silicon steel sheets, plastics Cutting of products
It is also suitable for the forming of plastic materials such as blanking, stretching, and stamping of sheets, as well as the pressing of plastic and powder products, etc.
Whether it is noise, speed, The power consumption is better than that of ordinary hydraulic punch presses. It is a new generation hydraulic punch press with high efficiency, high speed, high output and high environmental protection. This machine is the most widely used in the die-casting industry.
Product features of aluminum-magnesium product trimming machine:
This series of hydraulic machine tools uses -100% liquid pressure as the power source and is connected to an external three-phase or three-phase AC power supply.
. This series of equipment uses liquid as the medium to transmit energy. It adopts advanced hydraulic circuit of master and sub-cylinders. The oil temperature is low, the idle stroke speed is above /second, and the working speed is below /second.
The hydraulic edge trimming machine is in standby mode and makes much less noise when moving up and down quickly than similar products.
It adopts a four-column and three-plate structure. The vertical accuracy of the movable plate is controlled by four precision guide bushes. The parallel accuracy of any point between the lower working surface and the upper working surface reaches below.
The punch machine has a waste blowing device and a waste dropping chute in the center of the lower workbench.
The punching bottom dead center position of the punching machine is generally controlled by a pressure switch and a position sensor.
The edge trimming machine has an automatic counting function and is divided into two control modes: manual and semi-automatic. Manually, the press-fit upper mold can be stopped within any range of travel. It is equipped with an emergency recovery button and can also be equipped with an infrared hand guard device. .
Customers can adjust the pressure, stroke, punching speed, blowing time, and closing height for easy operation.
The hydraulic system has a built-in fuel tank at the bottom, with a clean and stable appearance.
, The output range of this series of hydraulic machinery is - optional.(.)