Year1
- 功率：
- 150W
- 光源种类：
- 金卤灯/钠灯
- 防护等级：
- IP65
Model:
Light source: Metal halide lamp/sodium lamp
Power:
Brand: Ronglang
Specifications:, 3, 3,
Installation method: ceiling type, wall type B, seat type
3-Waterproof, dustproof, shockproof and anti-glare lamp
Light source: metal halide lamp High-pressure sodium lamp
Power
Order model: (Metal halide lamp source)
(High-pressure sodium lamp)
Scope of application:
3-Widely applicable to tunnels, roads, bridges, and large facilities Flood lighting of roads and passages in factories, stations and other places.
Technical parameters:
3-Rated voltage:
Shell protection:
Insulation level:
Anti-corrosion level:
Inlet thread:
Lead-in cable:~
Pitch-to-height ratio:
Overall dimensions:
Structural characteristics:
3-Use protective angle design and mirror coating technology to achieve anti-glare effect, which can effectively reduce It will irritate the eyes of workers and construction workers to avoid discomfort and fatigue
Use a gas discharge light source with high light efficiency and long life, with a power factor greater than ., high light efficiency and good light transmittance
Special sealing and surface coating treatment to ensure that the lamps will never corrode or rust in harsh environments such as humidity and high temperature
Various installation methods such as seat type, ceiling type and wall-mounted type, the illumination angle can be adjusted according to the needs of the environment. Adjustable in a wide range of up and down.
How to use:
According to the site environment and lighting needs, determine the installation location and appropriate installation method of the lamps and ballasts. And prepare three-core cables of corresponding length according to the distance from the ballast to the power contact.
Fix the lamp and ballast at the determined installation position.
Tighten the bolts with a socket wrench, introduce one end of the three-core cable into the ballast cavity through the introduction device of the ballast output port, connect the wires to the terminals of the ballast, and then use the lead wires Clamp the three-core cable tightly and then tighten the compression nut.
Close the ballast box cover and tighten the fastening bolts, and then connect the other end of the three-core cable to the power supply to achieve lighting.
When replacing the light bulb, cut off the power supply first.
Notes:
When installing and maintaining lamps, the power supply must be disconnected first.
Non-professionals are not allowed to disassemble the lamps at will.
When in use, there will be a certain temperature rise on the surface of the lamp. This is a normal phenomenon and the center temperature of the transparent parts is higher and should not be touched.
When changing light bulbs, bulbs of the same type and power should be used. If the type or power of the light bulb is changed, the supporting ballast should be replaced accordingly.
Quality Assurance:
3- Strictly implement the international quality management system standard production to ensure that product quality fully meets national standards and design requirements. The product is subject to an annual housing warranty (light source warranty. Years), since purchase Within one year from that date, if any malfunction occurs during normal use of the product, Ronglang Electric will be responsible for free maintenance.
33-Waterproof, dustproof and anti-corrosion factory lights, 3-Power plant floodlights
WhatsApp
