Year1
- 功率：
- 70W/100W/150W
- 光源种类：
- 金卤灯/钠灯
- 防护等级：
- IP65
'
'
-Anti-glare lamp
'
'
' Waterproof, dustproof, shockproof, anti-glare lamp, metal halide lamp floodlight Power plant lighting
'
' Scope of application:
Widely used for flood lighting of roads and passages in tunnels, roads and bridges, large facilities, factories, stations and other places.
'Technical parameters:
Rated voltage:
Shell protection:
Insulation level:
Anti-corrosion level:
Inlet thread:
Introduction Cable:~
Pitch-to-height ratio:
Overall dimensions:
' - Waterproof, dustproof, shockproof and anti-glare lamp structural characteristics:
Using protective angle design and mirror coating technology to achieve anti- The glare effect can effectively reduce the irritation to the eyes of workers and construction workers, and avoid discomfort and fatigue
Using a gas discharge light source with high light efficiency and long life, the power factor is greater than., high light efficiency and good light transmittance
br/>Special sealing and surface coating treatment ensure that the lamps will never corrode or rust in harsh environments such as humidity and high temperature
Various installation methods such as seat type, ceiling type and wall-mounted type, irradiation The angle can be adjusted within a wide range of up and down according to environmental needs.
' How to use:
According to the site environment and lighting needs, determine the installation location and appropriate installation method of the lamps and ballasts. And prepare three-core cables of corresponding length according to the distance from the ballast to the power contact.
Fix the lamp and ballast at the determined installation position.
Tighten the bolts with a socket wrench, introduce one end of the three-core cable into the ballast cavity through the introduction device of the ballast output port, connect the wires to the terminals of the ballast, and then use the lead wires Clamp the three-core cable tightly and then tighten the compression nut.
Close the ballast box cover and tighten the fastening bolts, and then connect the other end of the three-core cable to the power supply to achieve lighting.
When replacing the light bulb, cut off the power supply first.
' -Note:
When installing and maintaining lamps, the power supply must be disconnected first.
Non-professionals are not allowed to disassemble the lamps at will.
When in use, there will be a certain temperature rise on the surface of the lamp. This is a normal phenomenon and the center temperature of the transparent parts is higher and should not be touched.
When changing light bulbs, bulbs of the same type and power should be used. If the type or power of the light bulb is changed, the supporting ballast should be replaced accordingly.
' Name: Waterproof, dustproof, shockproof and anti-glare lamp
Model:
Light source: Metal halide lamp/sodium lamp
Power:
Brand: Ronglang
Specifications :, 3, 3,
Installation method: ceiling type, wall type B, seat type
3-Waterproof, dustproof, shockproof and anti-glare lamp
Light source: metal halide lamp, high pressure sodium lamp
Power
Order model: (Metal halide light source)
3 (High pressure sodium lamp)
'
'
'
' Quality assurance:
3- Floodlight
Strictly implement the international quality management system standards for production to ensure that product quality fully meets national standards and design requirements. The product is subject to an annual warranty for the shell (light source warranty. Years), within one year from the date of purchase , if any failure occurs under normal use of the product, Ronlang Electric will be responsible for free maintenance.
WhatsApp
