Good news for the laundry industry, centrifugal dehydrator, fabric and knitted material dehydrator, three-legged industrial hardware water spinner, stainless steel food and vegetable spin dryer, factory direct sales

Good news for the laundry industry: centrifugal dehydrator, cloth knitted material dehydrator, three-legged industrial hardware water spinner, stainless steel food and vegetable spinner, manufacturer direct sales/consultation hotline: Miss Su/Industrial dehydrator structure: / Generally a three-legged pendulum structure , the three legs are equipped with springs at the bottom to avoid vibration caused by unbalanced load. Its material contact surfaces are all made of international 3 stainless steel plates, which are strong, durable and stable. The brake is equipped with a brake opening and closing arm, which has good braking performance, safety and reliability. Using triangle belt transmission, the motor drives the starting wheel, slowly starting to the normal speed, and the operation is smooth and vibration-free. There is a guide tube at the bottom to facilitate the timely flow of liquid out of the barrel. The screen and outer shell can be replaced and cleaned. After each dehydration, rinse it with clean water and place it in a ventilated place to air dry. It has the characteristics of large capacity and low consumption. It has an excellent safety control system for shockproof, timing, automatic and safe. / / Industrial dewatering machines generally have a three-legged suspension structure. The three legs are equipped with springs to avoid foot vibration caused by unbalanced loads. /. The inner tank shell is made of stainless steel plate, which is strong and durable. The cage base and chassis are all made of cast iron, and the water outlet pipe is under the chassis. / , The main shaft is made of high-quality stainless steel and has been heat-treated and finished / , It is driven by triangle belt, and the centrifugal starting wheel is directly driven by the motor, which can make the machine start slowly and gradually reach the design speed to ensure the smooth operation of the machine / , Brake Generally, it is equipped with a twitch opening and closing arm. It has good braking performance and can quickly stop the machine. It is safe and reliable. // Precautions for operating the plastic dehydrator: // 1. This dehydrator is only suitable for crushed pellets or small pieces. Do not put lumps, filaments or large objects into the machine to avoid jamming the machine. / 2. Before putting in the materials, the no-load period should be started for one minute. Only when no abnormalities are found can the materials be put in and dehydrated. / 3. If severe vibration or abnormal noise occurs after starting the machine, stop it immediately or cut off the power supply. First open the outer cover, then remove the screen, and check whether the spindle blades have fallen off or there are foreign objects. If the vibration cannot be eliminated after restarting, this If the machine cannot be used, check the cause first or notify the supplier for maintenance to avoid accidents. / 4. The dehydrator should be maintained regularly, and the main shaft bearing, feed bearing, and reducer should be regularly filled with butter and engine oil. The dehydrator should be thoroughly inspected after half a year of use.