Shengmeirui aluminum alloy baseboard accessories (ABS Yin and Yang angles, connectors), factory direct sales

Drilling process for skirting installation: Before drilling, observe the direction of the water and electricity wiring to prevent mistakes. The distance between drilling holes should not be too large, otherwise it will be difficult for the baseboard to stick to the wall.
Use special tools to drill holes in the wall. The common length of aluminum alloy baseboards is. In order to fix the baseboards more firmly, the intervals between drill holes should be on the left and right, and the intervals at the interfaces should be smaller.
Nail the small wooden strip into the hole you just drilled. The nails that fix the baseboard are nailed to this wooden strip and are nailed directly to the wall. The nails are easy to loosen.
Note: Since the pipes of the water and electricity project are buried in the wall, the position of the pipe is directly below the switch socket. When drilling, the position must be calculated to avoid damage.
Fixing: The wall must be leveled and cleaned before fixing the skirting. Otherwise, after the skirting is installed, it will not be completely close to the wall, leaving unsightly gaps.
Locate the location of the drilled holes and secure the baseboards with nails. When fixing, pay attention to whether the baseboard is close to the wall, and the nails should be completely embedded in the baseboard and cannot be seen.
Note: Whether the skirting is made of polymer, density board, or wood, it has the characteristics of thermal expansion and contraction. Therefore, the skirting near the corner should also be like the floor, leaving expansion joints on the left and right.
Corner treatment: At the corner, where the skirting lines intersect, the edges of the skirting lines should be cut at an angle, so that no ugly marks will be left at the interface. Fix the cut skirting. Note: The skirting lines in the corners must be cut at an angle before they can be spliced and installed, otherwise it will affect the appearance.
Installation points: Use special threaded nails to fix the baseboards. Such fixing effect is better and is not easy to loosen. Everyone should pay attention to whether manufacturers cut corners or cut corners.
The baseboards are originally designed to cover the expansion joints of the floor and make the floor more beautiful. Therefore, the edges where the skirting lines meet must be smoothed with a plane.
The baseboards should be completely close to the wall without leaving any gaps to be more beautiful, especially at the corners. The flatness of the wall should be tested before installation